Start; Quick Set Up - PURE Evoke-1S Owner's Manual

Start

Quick set up > Controls at a glance > Rear connectors

Quick set up

Unclip the aerial from the clip on the rear of the radio and fully extend it (steps A and B).
Insert the jack of the supplied mains adapter into the socket on the rear of the radio (C).
Aerial
USB
Designed and engineered in the UK
Plug the mains adapter into the mains supply (step D) and press the Standby button.
a) When you see the message 'Enable energy saving?' push the Tune dial.
b) Select 'On' to switch on energy saving mode (push the Tune dial).
Enable energy
saving?
When energy saving mode is switched on, the radio uses less power in standby
because it does not collect and store Intellitext messages in standby. It still collects
and stores Intellitext messages while the radio is switched on.
With energy saving mode switched on, the power consumption of EVOKE-1S in standby
is less than 1 Watt.
For more information: Intellitext
Wait for Evoke-1S to complete an Autotune for all available DAB stations (this takes
about a minute). When the Autotune is complete, a station will be selected.
PURE EVOKE-1S
Start
2
B
A
Designed in the UK Manufactured in China
6V DC
Aux Speaker Stereo Out Aux In
Manufactured in China
1
Now tuning...
Aerial
D
Designed and engineered in the UK
Tune
Energy saving
On
> page 9 energy saving mode
A
Designed in the UK Manufactured in China
C
6V DC
USB Aux Speaker Stereo Out Aux In
Manufactured in China
Tune
> page 12
BBC Radio 2
Talking to the people wh
6V DC
EcoPlus