Installation Procedure 1. To prevent short circuits, remove the key from the ignition and disconnect the - terminal of the battery. 2. Make the proper input and output wire connections for each unit. 3. Connect the wire on the wiring harness. 4.
Page 4
Connect to vehicle's reverse lamp harness when Connect to the terminal that is grounded when either the telephone rings or during conversation. To connect the Kenwood navigation system, consult your navigation manual. Connect either to the power control terminal when using the optional power amplifier, or to the antenna control terminal in the vehicle.
Gray Gray/Black White White/Black Green Green/Black DDX5022/DDX5022Y/DDX52RY 2WARNING Functions Connecting the ISO Connector The pin arrangement for the ISO connectors depends on the type of vehicle you drive. Make sure to make the proper connections to prevent damage to the unit.
System Connection USB terminal USB device (commercially available) Do not connect. ■ Audio Input Resistance-free stereo type mini plug (3.5φ) ■ Visual Input Resistance-free mini plug (3.5φ) ■ Rear View Camera Input • Visual input (Yellow) ■ Audio/Visual Output • Visual output (Yellow) ■...
Installation for Monitor/Player Unit Screw (M4X8) (commercially available) Self-tapping screw (commercially available) Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). Installing the Escutcheon Firewall or metal support Metal mounting strap (commercially available) Accessory 3...
• The frame can be removed from the top side in the same manner. 2. When the lower level is removed, remove the upper two locations. DDX5022/DDX5022Y/DDX52RY Removing the Unit 1. Remove the hard rubber frame by referring to the removal procedure in the section <Removing the Hard Rubber Frame>.