Audio Adjustments; Audio Control; Audio Setup; Speaker Setting - Kenwood KDC-MP242U Instruction Manual

Audio Adjustments

Audio Control

You can adjust following Audio Control items;
Adjustment Item Display
Subwoofer level "SW L"
Bass Boost "B.BOOST"/ "B.B"
System Q "NATURAL"/ "ROCK"/
"POPS"/ "EASY"/
"TOP40"/ "JAZZ"/
"GAME"/ "USER"
Bass level* "BAS L"
Middle level* "MID L"
Treble level* "TRE L"
Balance "BAL"
Fader "FAD"
Exit Audio Control mode (Volume control mode)
* Source tone memory: Puts the set up value in the
memory per source.
⁄
• "USER": This appears when Bass level, Middle level, and
Treble level are adjusted. When "USER" is selected, these
levels are recalled.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Control mode
Press the [AUD] knob.
3
Select the Audio item to adjust
Press the [AUD] knob.
4
Adjust the Audio item
Turn the [AUD] knob.
5
Exit Audio Control mode
Press any button.
Press a button other than the [AUD] knob.

Audio Setup

You can set Sound system, such as follows;
Range
–15 — +15
"1"/"2"/"OFF" (The
indicator turns on
according to the setting.)
Natural/Rock/Pops/Easy/
Top 40/Jazz/Game/User
setting
1
–8 — +8
–8 — +8
2
–8 — +8
Left 15 — Right 15
3
Rear 15 — Front 15
4
5

Speaker Setting

Fine-tuning so that the System Q value is optimal
when setting the speaker type as follows;
1
2
3
4
Adjustment Item Display
Low Pass Filter "LPF"
Volume offset "V-OFF"
⁄
• Volume offset: Sets each source's volume as a difference
from the basic volume.
Select the source to adjust
Press the [SRC] button.
Enter Audio Setup mode
Press the [AUD] knob for at least 1 second.
Select the Audio Setup item to adjust
Press the [AUD] knob.
Adjust the Audio setup item
Turn the [AUD] knob.
Exit Audio Setup mode
Press the [AUD] knob for at least 1 second.
Speaker type Display
OFF "SP OFF"
For 5 & 4 in. speaker "SP 5/4"
For 6 & 6x9 in. speaker "SP 6*9/6"
For the OEM speaker "SP OEM"
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
Enter Speaker Setting mode
Press the [AUD] knob.
Select the Speaker type
Turn the [AUD] knob.
Exit Speaker Setting mode
Press the [AUD] knob.
Range
80/120/160/Through(OFF) Hz
–8 — ±0 (AUX: –8— +8)
11
|
English