Kenmore 350 Series Owner's Manual page 12

Water softeners with deluxe valve
Table of Contents

Advertisement

Before installing the bypass valve, or
copper tube, be sure the turbine and
support are firmly in place in the
valve outlet port.
INSTALLING 3 VALVE BYPASS AND PIPES
Complete the following steps to install the three (3)
valve bypass:
• Cut the house main water pipe where you will con-
nect the softener.
• Loosely put together pipe, fittings, and the three
(3) valves.
• Place valve(s) within easy reach.
When all pipe, fittings and valves make a good fit
together, tighten all threaded joints (use pipe dope
on outside threads), or solder all sweat joints.
12
Install Plastic Bypass Valve
Turbine
Sensor Port
Support
Turbine
FIG. 10
Install 3-Valve Bypass
Questions? Call The Kenmore Water Line 1-800-426-9345
INSTALLING HOLDING CLIPS
Black Clip
Bypass Valve or
Installation Adaptor
Clip Snaps into Place
Between Larger Diameter Rings
BYPASS VALVE TURNED DOWNWARD
IN
3 VALVE BYPASS
Cross Section of Valve
Inlet or Outlet
O-Ring
FIG. 11
Turn bypass valve upside
down to connect to floor
level plumbing.
OUT
FIG. 12
FIG. 13
TO
Softener Inlet

Advertisement

Table of Contents
loading

Table of Contents