Step 4: Install Ro Assembly - Kenmore ULTRAFILTER 150 625.385700 Owner's Manual

- STEP 3: INSTALL FAUCET (cont.)-
UltraFilter 350
channel
locking tabs
valve lever
FAUCET ELECTRONICS
The faucet will measure the length of time the filters
have been installed (6 months). The faucet has an in-
dicator LED that flashes to inform you of the status
of the filter.
Green - Filter is good. Red - Filters need replacing.
In order to reset the monitor time feature, the battery
should be removed for a minimum of five seconds
and then reinserted.
The battery needs to be replaced when indicater
LEDs no longer light. Use only 3 volt sealed lithium
batteries. Improper placement of battery could dam-
age electronics. Use care when inserting battery to
align it correctly.
To change the battery, pull the spout and bezel from
the faucet base. The bezel will stay on the spout.
Pinch the two tabs (under bezel on faucet) with one
hand and with the other, pull up on the knob.
Change battery. Assemble the the knob, and spout
and bezel back onto the faucet base.
Figure 8
- STEP 4: INSTALL RO ASSEMBLY -
Hang the assembly on the included hanger washers,
or lay on the cabinet floor, as desired.
1. Refer to Figure 9 for wall mounting. Hold the as-
sembly up to the wall surface and mark locations for
the hanger washers. Distance needed is 7.2"
(approx. 7-7/32") apart.
2. Install hanger washers at least 15-1/2" up from the
cabinet floor, allowing room to remove sumps from
filter heads. Wood screws are provided, or obtain
other fasteners as needed.
15-1/2"
min.
up from
floor
Figure 9
9
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line