Table of Contents
Advertisement
OWNER'S
MANUAL
MODEL NO.
UltraFilter 150
625.385700
UltraFilter 350
625.385720
Caution:
Read and Follow
All Safety Rules and
Operating
Instructions
Before First Use of
This Product.
If you have questions
when
installing,
operating
or
maintaining
your
reverse
osmosis
system,
call
this
toll-free
number...
1-800-426-9345
(M-F,
7am-8pm,
CST)
For
repair
or replacement
parts, call this toll-free
num-
ber...
1-800-366-7278
See back cover for other
Sears service
numbers.
www.KenmoreWater.com
SAVE THIS
MANUAL
Reverse Osmosis
Drinking Water System
_i, Warranty
_i, How To Install
_i, How It Works
_i, Care Of
_i, Repair Parts
System tested and certified
by NSF International
to NSF!ANSl
Standard
58 for the reduction
of the
claims specified
on the performance
data sheet.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U. S. A.
PRINTEDtN
U.S.A.
Part No. 7266568 (Rev. H 8/4/05)
Advertisement
Table of Contents
Related Manuals for Kenmore ULTRAFILTER 150 625.385700
Summary of Contents for Kenmore ULTRAFILTER 150 625.385700
- Page 1 OWNER'S MANUAL MODEL NO. UltraFilter 150 625.385700 UltraFilter 350 625.385720 Caution: Read and Follow All Safety Rules and Operating Instructions Before First Use of This Product. If you have questions when installing, operating maintaining your reverse osmosis system, call this toll-free number...
-
Page 2: Warranty
Supply" on page osmosis membrane contains for storage and shipment. Be sure to purge on page 11 before using product Kenmore Water Line arranged to be cor- of influ- as N only for provided supply out- Temper- sys- con- a pre- water. -
Page 3: What Your Reverse Osmosis System Will Do
HANGER WASHERS & SCREWS ULTRAFtLTER 150 TUBING ADAPTER ULTRAFILTER WATER SUPPLY RO PRODUCT FITTING WATER FAUCET Kenmore Water Line tastes after waste, for drink- to buy of tubing,... -
Page 4: Where To Install The Ro System
UItraFilter 150 adapter drill and bits, if hole is needed RO Assembly Storage Tank, Make Remaining Pressure Testing, Purging Kenmore Water Line observing water to the RO fitting as typical- for re- drain, 19. A for the RO Tub-... -
Page 5: Step 1: Install Cold Water Supply Fitting
(using compression fitting) - parts not included - 1/4" compression fitting insert ferrule 1/4" tubing to RO inlet (see step 2, on page 8) Kenmore Water Line connec- stan- type and open 3B. If... -
Page 6: Step 2: Install Drain Adapter
1-1/4" plumbers putty around drilled Figure 7) to prevent water Kenmore Water Line 4_.._ _2:00 products installer Dril- diameter hole leakage... - Page 7 Call 1-800-426-9345 faucet & spout hole in sink or b__i_ bers "" washer -..._ ( _ tubing adaptor hex nut _ (connects to /bottom of stud) 3/8" black tubing drain point (connect to 3/8" barb on faucet) Kenmore Water Line...
- Page 8 Figure 7 Call 1-800-426-9345 faucet & spout bezel gasket plumbers putty 1/4" tubing to 1/4" red tubing spacer J 3/8" tubing to drain point 1/4" red 3/8" tubing tubing TUBING RO SYSTEM Kenmore Water Line on RO...
-
Page 9: Step 4: Install Ro Assembly
Use care when inserting battery pull the spout and bezel from The bezel will stay on the spout. bezel on faucet) with one other, pull Assemble the the knob, base. 15-1/2" min. up from floor Kenmore Water Line knob. spout... -
Page 10: Installation
Again, to be sure it's held firmly in the fitting. UNDERSINK INSTALLATION 3/8" BLACK TUBING Note: See note on page 4 regarding tubing lengths. Kenmore Water Line tape fit- then installed pull on... - Page 11 RO faucet. step 1 five more times (for a total of 6) to Then the RO system product water for use. Kenmore Water Line with 5.25% it will head Then idle for 20 and run steps (left side) puple...
-
Page 12: How Your Reverse Osmosis System Works
1 / 4" red drain drain port. Kenmore Water Line high operated is built 350) of the fil- to be re- has an tank has faucet... -
Page 13: Care Of Your Reverse Osmosis System
RO mem- spillage, place a container or put the RO assembly in a container Before disconnecting parts, supply valve to the RO. Kenmore Water Line replacing under be sure to... - Page 14 Turn oppo- site way to install and tighten. Figure Call 1-800-426-9345 models). approved for use on a potable RO Cartridge (cartridge o-ring seals on this end poetfilter cartridge (cartridge o-ring seals on this end) sump Kenmore Water Line...
- Page 15 (control) insert 1/4" tubing DRAIN Kenmore Water Line of the water...
- Page 16 SHUTOFF SERVICE assembly requires service, be sure to parts exactly as shown in Figure SHUTOFF ASSEMBLY o-ring spring ball Kenmore Water Line valve check...
-
Page 17: Other Troubleshooting
Inspect and eliminate restriction or plug. Refer to installation instructions for proper drain connection. Clean, repair or replace as needed. Replace with new batteries. Install batteries correctly. Replace flow restrictor. port. Change filters. after servicing inner parts Call 1-800-426-9345 of the system(see page 11). Kenmore Water Line... - Page 18 10 gpg 4 - 10 14 gal. 5 gal. 90 - 95 2.3 gal. 16 % claims as verified and sub- Kenmore 13" Metric 280 - 690 kPa 5 - 40°C 53 liters 18.9 liters 8.7 liters amount of waste...
-
Page 19: Remote Installation
This type of over the p-trap drain Always be sure to provide the end of the hose colors as 1/4" green tubing , \\ [ oo.o Kenmore Water Line bypas- adapter. the drain _V_TpE_... -
Page 20: Repair Parts
- REPAIR PARTS - Kenmore Reverse Osmosis Drinking Water System, Model Nos. 625.385700 & 625.385720 Manifold Housing PUSH - IN FITTINGS 1/4" _21 3/8" o- ring seal eollet 19_i... • 1/4" Tubing -... Problems, Questions? Call 1-800-426-9345 Kenmore Water Line... - Page 21 Tubing, 3/8" x 20' - white [_• Tubing, 3/8" x 100' - white _• Optional Drain Adaptor • Suppl. Storage Tank, 3.2 gallon • Grease for O-Rings • for colored lengths in the manifold housing Kenmore Water Line of tub- only.
- Page 22 - NOTES- Problems, Questions? Call 1-800-426-9345 Kenmore Water Line...
- Page 23 - NOTES- Problems, Questions? Call 1-800-426-9345 Kenmore Water Line...
- Page 24 OWNER'S MANUAL MODEL NO. UltraFilter 625.385700 UltraFilter 625.385720 model number your reverse osmosis system is found on the rating decal. This decal is on the back of the R. O. sump. When requesting service or ordering parts, always provide the following formation: _I, Product Type _I, Model Number...