Audio Dubbing - JVC Model HR-DVS1U Instructions Manual

60
EN

Audio Dubbing

Audio component
(CD player etc.)
NUMBER "0"
1
PLAY
Audio cable
CH
T W
1 2 3
2
4 5 6
7 8 9
0
4
VHS
DV VHS
PAUSE
VHS Audio Dubbing
Audio dubbing replaces the normal audio sound of a previously
recorded tape with a new soundtrack. Use your VCR as the
recorder.
Normal audio track
Video/Hi-Fi audio
track
DV Audio Dubbing
This function lets you record new audio, without erasing the
original audio, on a DV tape that was recorded with "SOUND
MODE" set to "32kHz" (
audio that you recorded by connecting other audio or video
equipment to this VCR.
You cannot perform audio dubbing on a tape that was recorded
with "SOUND MODE" set to "48kHz", on a tape that was
recorded at the "LP" speed, or on a blank tape.
MAKE CONNECTIONS
1
Connect an audio component to the AUDIO IN L + R
connectors on the VCR's front panel. *When connect-
ing monaural equipment, use only the VCR's AUDIO
IN L connector.
SELECT RECORDING DECK
2
Press VHS or DV.
When using the DV deck as the recording deck, press
so that the audio signals from the AUDIO L + R
input connectors can be recorded.
SET INPUT MODE
3
Press the remote control's NUMBER key "0" and CH so
that "L-2" appears in place of a channel number.
LOCATE START POINT
4
Press PLAY to start playback of the tape in your VCR,
and press PAUSE when you find the point where you
want to start dubbing.
ENGAGE AUDIO DUBBING
5
Press A. DUB.
Your VCR enters the Audio Dubbing Pause mode.
( blinks, and
panel.)
EDITING (cont.)
Pre-recorded tape
Audio-dubbed tape
pg. 33). You can then play back
light up on the front display