Adjusting The Volume; Listening Only With Headphones - JVC RX-6020VBK Instructions Manual

Audio/video control receiver
Hide thumbs Also See for RX-6020VBK:
Table of Contents

Advertisement

Changing the source name
When you connect the CD recorder to the
TAPE/CDR jacks on the rear panel, change the
source name shown on the display.
1
Press TAPE/CDR (SOURCE NAME).
• Make sure "TAPE" appears on the display.
2
Press and hold SOURCE NAME (TAPE/CDR)
until "ASSIGN CDR" appears on the display.
To change the source name from "CDR" to "TAPE," repeat the
same procedure above (in step 1 , make sure "CDR" appears on the
display).
Note:
Without changing the source name, you can still use the connected
component. However, there may be some inconvenience:
– "TAPE" will appear on the display when you select the CD
recorder.
– You cannot use the digital input (see page 11) for the CD recorder.
– You cannot use the COMPU LINK remote control system (see page
25) to operate the CD recorder.
Selecting different sources for each picture and
sound
You can watch picture from a video component while listening to
sound from another component.
Press one of the audio source selecting buttons—CD, TAPE/CDR,
FM, AM (FM/AM), while viewing the picture from a video
component such as the VCR or DVD player, etc.
CD
TAPE/CDR
FM
SOURCE NAME
On the front panel
Note:
Once you have selected a video source, pictures of the selected
source are sent to the TV until you select another video source.
Remote
NOT
TAPE/CDR
SOURCE NAME
TAPE/CDR
CD
DVD
DVD MULTI
AM
FM/AM
TV SOUND
VCR
From the remote control

Adjusting the Volume

On the front panel:
To increase the volume, turn MASTER
VOLUME clockwise.
To decrease the volume, turn it
counterclockwise.
From the remote control:
To increase the volume, press VOLUME +.
To decrease the volume, press VOLUME –.
CAUTION:
Always set the volume to the minimum before starting any source. If
the volume is set at its high level, the sudden blast of sound energy
can permanently damage your hearing and/or ruin your speakers.
Note:
The volume level can be adjusted within the range from "0" (minimum)
to "50" (maximum).

Listening Only with Headphones

You must turn off speakers when you listen with headphones.
1
Connect a pair of headphones to the PHONES jack on the front
panel.
2 Press SPEAKERS ON/OFF.
• "HEADPHONE" appears for a while and the H. PHONE
indicator lights up on the display.
The H. PHONE indicator lights up.
ANALOG
L
R
This cancels the Surround mode currently selected, and activates
the HEADPHONE mode (see below).
HEADPHONE mode:
When using the headphones, following signals are output
regardless of your speaker setting:
— For 2 channel sources, the front left and right channel signals
are output directly from the headphones.
— For multichannel sources, the front left, right, center, and rear
channel signals are down-mixed and then output from the
headphones.
You can enjoy multichannel sound sources using the
headphones.
CAUTION:
Be sure to turn down the volume:
• Before connecting or putting on headphones, as high volume can
damage both headphones and your hearing.
• Before turning on speakers again, as high volume may output from
the speakers.
MASTER VOLUME
VOLUME
Remote
NOT
H.PHONE
9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rx-6022vsl

Table of Contents