Connecting Speakers - JVC MX-K5 Instructions Manual

AM antenna
1
2
ANTENNA
[ ] AM
FM 75
AM loop antenna
(supplied)
1
Press and hold the clamp of the AM terminal
on the rear of the unit.
2
Insert the end of the AM loop antenna cord
into the terminal.
3
Release the finger from the clamp.
4
Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM terminal and extend it horizontally. (The AM loop
antenna must remain connected.)
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.

Connecting Speakers

Vinyl-covered wire
(not supplied)
1
2
3
– 7 –
1
Red
SPEAKER
[ 6-16
Speaker
cord
R
(red/black)
Black
from right
speaker's
terminals
Press and hold the clamp of the speaker
terminal on the rear of the unit.
Insert the end of the speaker cord into the
terminal.
Match the polarity (colors); Red (+) to red (+) and black
(–) to black (–).
Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
2
]
Speaker
cord
L
(red/black)
from left
speaker's
terminals