Changing The Display Brightness; Adjusting The Audio Input Level; Setting The Clock; Turning Off The Power Automatically - JVC CA-UXG30 Instructions Manual

Changing the Display Brightness

You can dim the display window.
DIMMER
DIM 1
(Initial setting)
DIM 1 Dims the display and the illumination on the
main unit.
DIM 2 Dims the display more than DIM 1 and turns
off the illumination on the main unit.

Adjusting the Audio Input Level

If the sound from a component connected to the AUX jack is
too loud or is too quiet, you can change the audio input level
through the AUX jack (without changing the volume level).
While AUX is selected as a source...
2 sec.
AUX LVL1
SET
AUX LVL 1
Select this when the sound is too loud.
AUX LVL 2
AUX Level 2 is preset at the intermediate
level between Level 1 and 3.
AUX LVL 3
Select this when the sound is too quiet.

Setting the Clock

Without setting the built-in clock, you cannot use Daily
Timers (see page 16) and Sleep Timer.
• To exit from the clock setting, press CLOCK as required.
• To go back a step, press CANCEL.
1
Activate the clock setting mode.
CLOCK/
TIMER
S.TURBO
QP Link
• If you have already adjusted the clock before, press the
button repeatedly until the clock setting mode is
selected.
11
DIM 2
DIM OFF
Remote
ONLY
AUX LVL2
AUX LVL3
(Initial setting)
Remote
ONLY
2
Adjust the hour, then the minute.
PRESET/GROUP/PTY
DOWN UP
Now the built-in clock starts working.
To check the current time during play
DISPLAY
Clock
MODE
Source information
* Only while FM is selected as a source (see page 12)

Turning Off the Power Automatically

Auto Standby
2 sec.
A. STANDBY
When Auto Standby is in use, the A.STBY indicator lights
on the display.
The A.STBY indicator starts flashing:
• When disc playback stops
• When the sound signal from the AUX jack stops or is too
weak
The System will turn off (on standby) automatically if no
operation is done for about 3 minutes while the indicator is
flashing.
Sleep Timer
You can set the unit to turn off after a certain period of time.
1
Specify the time (in minutes).
SLEEP
10 20
2
Wait until the set time disappears.
To check the time remaining until the shut-off time
SLEEP
S.TURBO
QP Link
• If you press the button repeatedly, you can change the shut-
off time.
SET
( PS PTY RT )
Remote
ONLY
On
Canceled
30 60 90 120 150
Canceled
SLEEP
*