Connecting The Speakers - JVC RX-5020VBK Instructions Manual

Connecting the Speakers

After connecting the front, center, rear speakers and/or a subwoofer,
set the speaker setting information properly to obtain the best
possible Surround effect. For details, see pages 12 to 14.
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
Connecting the front, center and rear speakers
2
1
For each speaker, connect the (+) and (–) terminals on the rear panel
to the (+) and (–) terminals marked on the speakers.
1 Cut, twist and remove the insulation at the end of
each speaker cord.
2 Open the terminal (1), then insert the speaker
cord (2).
3 Close the terminal.
Connecting the subwoofer speaker
By connecting a subwoofer, you can enhance the bass or reproduce
the original LFE signals recorded in the digital software.
Powered subwoofer
Connect the input jack of a powered subwoofer to the
SUBWOOFER OUT jack on the rear panel, using a cable with RCA
pin plugs (not supplied).
• Refer also to the manual supplied with your subwoofer.
Since bass sound is non-directional, you can place a
subwoofer wherever you like. Normally place it in front of
you.
3
1
2
SUBWOOFER
OUT
Speaker layout diagram
"YES" for the subwoofer and "SMALL" for the front, center
and rear speakers are initial settings. To get best possible
sound, change the subwoofer and speaker settings to fit your
listening conditions (See pages 12 and 13).
Center
speaker
Left front
speaker
RX-5020V AUDIO/VIDEO CONTROL RECEIVER
FM/AM TUNING FM/AM PRESET FM MODE
STANDBY MEMORY
STANDBY/ON D I G I T A L
S U R R O U N D
SURROUND ON/OFF INPUT ANALOG INPUT DIGITAL
INPUT ATT DVD VCR TV SOUND
SURROUND MODE SPEAKERS ON/OFF
CD TAPE/CDR FM/AM
SOURCE NAME
PHONES
Left rear
speaker
To
subwoofer
To center speaker
To right front speaker
To right rear speaker
Right front
Subwoofer
speaker
MASTER VOLUME
ADJUST SETTING
DOWN CONTROL UP
Right rear
speaker
To left
front speaker
To left
rear speaker
5