Operating Jvc's Audio/Video Components; Operating Audio Components - JVC RX-5020VBK Instructions Manual

Operating JVC's Audio/Video Components

You can use the remote control to operate other JVC's
components.

Operating Audio Components

IMPORTANT:
To operate JVC's audio components using this remote control:
• You need to connect JVC's audio components through the COMPU
LINK (SYNCHRO) jacks (see page 24) in addition to the
connections using cables with RCA pin plugs (see page 6).
• Aim the remote control directly at the remote sensor on the receiver.
• If you use the buttons on the front panel, the remote control will not
operate that source. To operate a source with the remote control,
the source must be selected using source selecting buttons on the
remote control.
• To operate the cassette deck or CD recorder using the COMPU
LINK remote control system, set the source name correctly. (See
page 8.)
• Refer also to the manuals supplied with your audio components.
TV CATV
A/V CONTROL
TEST
1
EFFECT
4
MENU
7/P
ENTER
10
RETURN
SOUND
PTY–PTY SEARCH–PTY
REW
REC PAUSE
TAPE/CDR CD
FM/AM TV SOUND
FM MODE FM MODE
TV/VIDEO SURROUND
VCR CH TV/CATV CH TV VOLUME
REMOTE CONTROL RM-SRX5020J
STANDBY/ON
RECEIVER
CENTER AUDIO
2 3
REAR L
TV/CATV
5 6
REAR R
VCR
8 9
SUBWOOFER
DVD
0 10
100
SLEEP
FF
CD–DISC
DVD
ANALOG
/DIGITAL
VCR
ON/OFF
MUTING
MODE
VOLUME
Sound Adjustment
You can always perform the following operations:
SURROUND ON/OFF : Turn on or off the Surround modes.
SURROUND MODE : Select the Surround modes.
After pressing SOUND, you can use the following buttons for sound
adjustment:
SUBWOOFER +/–
: Adjust the subwoofer output level.
CENTER +/– : Adjust the center speaker output level.
REAR•L +/– : Adjust the left rear speaker output level.
REAR•R +/– : Adjust the right rear speaker output level.
EFFECT : Select the DAP effect level.
TEST
: Turn on or off the test tone output.
Note:
After adjusting sounds, press the corresponding source selecting
button or CD-DISC to operate your target source by using the 10
keys; otherwise, the 10 keys cannot be used for operating your target
source.
Tuner
You can always perform the following operations:
FM/AM : Alternate between FM and AM.
FM MODE : Change the FM reception mode.
After pressing FM/AM, you can use the following buttons for tuner
operations:
1 – 10, +10 : Select a preset channel number directly.
• For channel number 5, press 5.
• For channel number 15, press +10, then 5.
• For channel number 20, press +10, then 10.
CD player
After pressing CD, you can use the following buttons for CD
operations:
3 3 3 3 3
: Start playback.
4
: Return to the beginning of the current
(or previous) track.
¢
: Skip to the beginning of the next track.
7 7 7 7 7
: Stop playback.
8 8 8 8 8 : Pause playback. To release it, press 3 3 3 3 3 .
1 – 10, +10 : Select a track number directly.
• For track number 5, press 5.
• For track number 15, press +10, then 5.
• For track number 20, press +10, then 10.
25