Forced Operation - LG LS-J0910CL Service Manual

8. Forced Operation

Operation procedures when the remote control can't be
used.
Open the front panel upward and move the Slide Switch
to the Forced Operation position.
If you want to stop operation, move the Slide Switch to
the Auto Restart or the Remote Control position.
In case the power comes on again after power failure on
the Forced Operation position, the operating conditions
are automatically set as follows:
During Forced Operation, the initial mode continues.
Operating mode
Indoor FAN Speed
Setting Temperature 22°C(72°F)
9. AUTO RESTART
In case the power comes on again after a power failure,
Auto Restarting Operation is the function to operate pro-
cedures automatically to the previous operating condi-
tions.
If you want to use this operation, Open the front panel
upward and move the slide switch to the Auto Restart
position.
If you do not want to use this operation, move the Slide
Switch to the Remote Control position.
Cooling
Room Temp. ≥ 24°C(76°F) 21°C(70°F) ≤ Room Temp. < 24°C(76°F) Room Temp. < 21°C(70°F)
Model
Cooling Cooling
High High
22°C(72°F)
Open the front
panel upward
Heat pump Model
Healthy Dehumidification
Healthy Dehumidification Rule
23°C(74°F)
Open the front
panel upward
When you are out for a while, put the Slide Switch
on the Remote Control.
- 21 -
Slide Switch
FORCED
OPERATION
Slide
AUTO
Switch
RESTART
REMOTE
CONTROL
Heating
High
24°C(76°F)
Slide Switch
FORCED
OPERATION
Slide
AUTO
Switch
RESTART
REMOTE
CONTROL