Ovens - Rangemaster Elite SE 110 Dual Fuel User's Manual & Installation Instructions

Fig.5-5
Glass Fronted Door Panels
The oven door front panels can be taken o so that the glass
panels can be cleaned. Move the cooker forward to gain
access to the sides (see the 'Moving the Cooker' section under
'Installation').
Open the oven door slightly and remove the front panel
xing screws from the door sides, two each side.
Carefully lift o the outer door panel. The inside face of the
glass panels can now be cleaned – take care not to disturb or
wet the door insulation.
Note: If the door is triple glazed then the inner two panels are
xed together and should not be separated.
After cleaning, carefully re t the outer door panel and replace
the side xing screws.
DO NOT use harsh abrasive cleaners or sharp metal
nn
scrapers to clean the oven door glass since they can
scratch the surface, which may result in shattering of
the glass.

Ovens

Handygrill
The pan and trivet should be washed in hot soapy water.
After grilling meats or any foods that soil, leave to soak for a
few minutes in the sink immediately after use.
Stubborn particles may be removed from the trivet by using a
nylon brush.
'Cook & Clean' Panels
The ovens have panels which have been coated with a special
enamel that partly cleans itself. This does not stop all marks
on the lining, but helps to reduce the amount of manual
cleaning needed.
The 'Cook & Clean' panels work better above 200 °C. If you do
most of your cooking below this temperature, occasionally
remove the panels and wipe with a lint free cloth and hot
soapy water. The panels should then be dried and replaced
and the oven heated at 200 °C for about one hour. This will
make sure the 'Cook & Clean' panels are working e ectively.
DO NOT use steel wool, oven cleaning pads, or any other
materials that will scratch the surface.
Removing the Oven Linings
Some of the lining panels can be removed for cleaning.
If you wish to clean the enamel interior of the oven, you
will need to remove the shelves before removing the 'Cook
& Clean' panels. You do not have to remove the support
brackets to remove the panels. Lift each panel upward and
slide forward o the support brackets (Fig.5-5).
Once the panels have been removed, the oven enamel
interior can be cleaned.
Re t in the reverse order.
16