Preparations - JVC EXAD KD-NX901 Instructions Manual

Hdd navigation/dvd receiver
Hide thumbs Also See for EXAD KD-NX901:
Table of Contents

Advertisement

Preparations

Before using the Navigation System first time, it is required to calibrate the Navigation System.
• After deleting the run time (DELETE RUNTIME: see page 21) or changing the installation angle
(UNIT ANGLE: see page 21), calibration is also required.
1
2
3
4
A
B
C
1
Turn on the ignition switch (either to
ON or to ACC).
2
Press
press NAVI/AV.
3
Select your preferred language and set
your measured angle.
• When shipped from the factory, navigation
language is set to UK English.
• See "Measuring the installation angle" on
the Installation/Connection Manual (and also
pages 20 and 21).
4
Confirm the following connections on
the screen.
GPS antenna A:
• GPS:OK \ Connection is OK.
• GPS:NG \ Antenna is disconnected or short-
circuited.
Parking brake lead B:
Step on the brake pedal, then disengage and
engage the parking brake repeatedly.
• If "PKG:OFF" appears when disengaged
and "PKG:ON" appears when engaged,
connection is OK.
Reversing signal lead C:
Engage the parking brake, step on the brake
pedal, then shift the gearchange lever.
• If "D:FWD/H" and "D:FWD/L" alternate
on the screen, connection is OK. (Only after
calibration is started, "REV" appears when
the gearchange lever is set to reverse.)
Speed signal lead D:
Drive the car for a while.
• If the number increases as you speed up the
car, connection is OK.
If connection is not good, check the connection.
D
to turn on the power, then
To be continued....
11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kd-nx901eKd-nx901

Table of Contents