Before Installation; Checking The Supplied Accessories; General Precautions; Handling The Unit - JVC RX-DV31 Instructions Manual

Before Installation

Precautions

General Precautions

• DO NOT insert any metal object into the unit.
• DO NOT disassemble the unit or remove screws, covers, or
cabinet.
• DO NOT expose the unit to rain or moisture.
Locations
• Install the unit in a location that is level and protected from
moisture.
• The temperature around the unit must be between 5˚C and
35˚C.
• Make sure there is good ventilation around the unit. Poor
ventilation could cause overheating and damage the unit.

Handling the unit

• DO NOT touch the power cord with wet hands.
• DO NOT pull on the power cord to unplug it. When
unplugging the cord, always grasp the plug so as not to
damage the cord.
• Keep the power cord away from the connecting cords and
the antenna. The power cord may cause noise or screen
interference. It is recommended to use a coaxial cable for
antenna connection, since it is well-shielded against
interference.
• When a power failure occurs, or when you unplug the
power cord, the preset settings such as preset FM or AM
channels and sound adjustments may be erased in a few
days.
1

Checking the Supplied Accessories

Check to be sure you have all of the following supplied
accessories.
The number in the parentheses indicates the quantity of the
pieces supplied.
• Remote control (1)
• Batteries (2)
• AM loop antenna (1)
• FM antenna (1)
• Composite video cord (1)
• AC plug adaptor (1)
If anything is missing, contact your dealer immediately.
Adjusting the Voltage Selector
Before connections, always do the following first if necessary.
Select the correct voltage in VOLTAGE SELECTOR on the
rear by using a screw driver.
Check to be sure if the voltage mark is set to the voltage for
the area where you use this unit.
VOLTAGE
110V SELECTOR
220V
127V
230-240V
Voltage mark
• Times given for various operations are for reference only.
Actual time will vary somewhat.
• The following mark is used in this manual to indicate
available disc types for the operations explained in each
section. Unavailable disc types are shown in halftone
color.
VOLTAGE
SELECTOR
110V
220V
127V
230-240V