Getting Started; Connecting The Am And Fm Antennas - JVC RX-DV31 Instructions Manual

Home cinema dvd-audio/video control center
Table of Contents

Advertisement

Getting Started

Connecting the AM and FM Antennas

AM loop antenna
(supplied)
Snap the tabs on the loop
into the slots of the base
to assemble the AM loop
antenna.
1
2
220V
230-240V
2
AM antenna connection
Connect the AM loop antenna supplied to the AM LOOP
terminals.
1
Remove the insulation if the AM loop antenna wire is
covered with vinyl.
2
Press and hold the clamp of the terminal (1), then insert
the wire (2).
3
Release the clamp.
Turn the loop until you have the best reception.
• If the reception is poor, connect an outdoor single vinyl-
covered wire (not supplied) to the AM EXT terminal. Keep
the AM loop antenna connected.
If AM reception is poor,
connect an outdoor
single vinyl-covered wire
(not supplied).
AM LOOP
AM EXT
ANTENNA
3
1
VOLTAGE
110V
SELECTOR
127V
CAUTION:
SPEAKER
IMPEDANCE
1 OR 2:
8
16
1 AND 2:
16
32
If FM reception is poor, connect
outdoor FM antenna (not supplied).
FM antenna (supplied)
FM 75
COAXIAL
CAUTION:
SPEAKER
IMPEDANCE
8
16
FM antenna connection
Connect the FM antenna supplied to the FM 75 Ω COAXIAL
terminal as temporary measure.
Extend the supplied FM antenna horizontally.
• If the reception is poor, connect an outdoor FM antenna
(not supplied). Before attaching a 75 Ω coaxial cable with a
connector (IEC or DIN45325), disconnect the supplied FM
antenna.
Note:
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. This could cause
poor reception.
6

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rx-dv31sl

Table of Contents