Advertisement
Quick Links
Parts Included in kit:
FM Modulator
Read and understand these instructions BEFORE attempting to install this product.
Recommended Tools:
.
Phillips Screw Driver
.
3/4'' Drill Bit
.
Plastic Trim Panel Removal Tool
.
10mm Socket & Ratchet
Noise can be introduced into the system if the source audio device is playing while
simultaneously being charged through the vehicle's 12V DC power outlet. If this noise is
excessive, please disconnect the DC charger.
For optimum sound quality, it is recommended to set the source audio device volume to
75% maximum output level, then use the head unit to adjust the volume.
INSTALLATION INSTRUCTIONS
HYUNDAI AUXILIARY JACK/FM MODULATOR
2007 HYUNDAI VERACRUZ
PART NUMBER: U8550-00100
2007 Hyundai Veracruz
Audio Input
Jack Connector
Switch Plate
Pocket Divider
.
Drill
.
3/32'' Drill Bit
.
Pliers
SPECIAL OPERATION NOTES
Felt
Wire Ties/ Felt/ Phillips
Head Screws/ Scotch Lock
4
/05
/
7 0
24'' Long 3.5mm to
3.5mm Audio Cable
a P
e g
1
o
4 f
Advertisement
Summary of Contents for Hyundai HYUNDAI AUXILIARY JACK/FM MODULATO
- Page 1 INSTALLATION INSTRUCTIONS HYUNDAI AUXILIARY JACK/FM MODULATOR 2007 HYUNDAI VERACRUZ PART NUMBER: U8550-00100 2007 Hyundai Veracruz Parts Included in kit: Audio Input Felt 24’’ Long 3.5mm to Jack Connector Wire Ties/ Felt/ Phillips FM Modulator Head Screws/ Scotch Lock 3.5mm Audio Cable...
- Page 2 You should have a clear view of the dash cavity. b. Remove (10) phillips screws from radio/AC panel. c. Pull radio/AC assembly out, unplug harness connectors and remove. STEP 2 Installing the FM Modulator Hyundai Factory Radio Harness Connector Green/ Black Stripe 3M Scotch Lock NOTE: Be sure to test with a Multi-Meter to verify.
- Page 3 STEP 2 Installing the FM Modulator (Contd.) STEP 3 Installing the Jack Connector Switch Plate Actual Size Drill Drill ..........Fig.4 SEE PAGE 4 Drill Drill ..........x Back view of storage bin Fig.1 10mm Socket a. Remove storage bin by removing (4) mounting screws. b.
- Page 4 Template Instructions (Step 3c) Step 1. Place bin illustration template over the actual bin of the vehicle. (See Fig.4) Be sure to align the boxed diagram directly onto the bin. Hint: Feel around on the boxed area on the bin illustration to check if the template is aligned to the bin as best as possible.