Power - JVC GR-D396US Instructions Manual

How To Attach The Core Filter
Attach the core filters to the cables. The core
filter reduces interference.
1
Release the stoppers on both ends of the
core filter.
Stopper
2
Run the cable through the core filter, leaving
approx. 3 cm (1-3/16") of cable between the
cable plug and the core filter.
Wind the cable once around the outside of the
core filter as shown in the illustration.
Core filter
3 cm (1-3/16")
3
Close the core filter until it clicks shut.
NOTES:
Take care not to damage the cable.
When connecting a cable, attach the end with the
core filter to the camcorder.

Power

This camcorder's 2-way power supply system
lets you choose the most appropriate source of
power. Do not use provided power supply units
with other equipment.
Charging The Battery Pack
Battery
pack
Arrow
Wind once
To AC outlet
1
Set the Power Switch to "OFF".
2
With the arrow on the battery pack pointing
downward, push the battery pack slightly against
the battery pack mount 1.
3
Slide down the battery pack until it locks in
place 2.
4
Connect the AC Adapter to the camcorder.
5
Plug the AC Adapter into an AC outlet. The
POWER/CHARGE lamp on the camcorder
blinks to indicate charging has started.
6
When the POWER/CHARGE lamp goes out,
charging is finished. Unplug the AC Adapter
from the AC outlet. Disconnect the AC Adapter
from the camcorder.
GETTING STARTED
Battery pack mount
1
To DC connector
AC Adapter
CONTINUED ON NEXT PAGE
13
EN
PUSH
BATT.
2
POWER/
CHARGE
lamp
Power switch