JVC KW-AVX716 Instructions Manual page 378

Symptoms
• Bluetooth device does not detect the unit.
• The unit does not detect the Bluetooth
device.
• The unit does not make pairing with the
Bluetooth device.
• Echo or noise occurs.
• Phone sound quality is poor.
• The sound is interrupted or skipped during
playback of a Bluetooth audio player.
• "New Device" cannot be selected for
"Bluetooth AUDIO."
• The connected audio player cannot be
controlled.
• "Reset 08" appears on the screen.
Remedies/Causes
This unit can be connected with one Bluetooth cellular
phone and one Bluetooth audio player at a time.
While connected to a device, this unit cannot be detected
from another device. Disconnect currently connected device
and search again.
• Check the Bluetooth setting of the device.
• Search from the Bluetooth device. After the device
detects the unit, select <Open> on the unit to connect
the device. (☞ page 27)
• Enter the same PIN code for both the unit and target
device. If the PIN code of the device is not indicated on its
instructions, try "0000" or "1234."
• Select the device name from <Special Device>, then
try to connect again. (☞ pages 28, 50)
Adjust the microphone unit position.
• Reduce the distance between the unit and the Bluetooth
cellular phone.
• Move the car to place where you can get a better signal
reception.
• Reduce the distance between the unit and the Bluetooth
audio player.
• Disconnect the player connected for "Bluetooth PHONE."
• Turn off, then turn on the unit.
• (When the sound is not yet restored,) connect the player
again.
Bluetooth audio player is already connected. To select "New
Device," disconnect it. (☞ page 28)
Check whether the connected audio player supports AVRCP
(Audio Video Remote Control Profile).
Check the connection between the adapter and this unit.
62