Ryger NAVIGATOR DMX Controller Instruction Manual page 4

At this point select Ok to save the fixture settings. After a brief moment you will be informed that the
save operation has been completed and you will be returned to the Setup menu. From the Setup menu
select Quit to return to the main menu.
Using DP40/SP40 MS units
The DP40MS and SP40MS allow DMX base addresses up to 61 only. This means that you can only
use fixtures 1-8 for DP40MS and SP40MS units. You should also note that the DMX base address
selection procedure is different to that outlined in the table above (please see the DP40/SP40MS
manual for details). As the DP40MS and SP40MS units are four channel devices you can place two of
these units on a single fixture by assigning the correct DMX base addresses. For example to set up
two DP40 or SP40 MS units to be used on fixture 1 you would set the first unit to use addresses 1 - 4
and the second unit to use addresses 5 - 8. For fixture 2 the first unit would be set to addresses 9 -12
with the second unit set to addresses 13 - 16. There are no named personalities in the Navigator for
these units - the default fixture type will allow control of both the SP40MS and the DP40MS units.
Using other manufacturers intelligent lighting
It is possible for the Navigator to control intelligent lighting fixtures from manufacturers other than
Ryger Electronics by using the programmable personality feature. To set up a fixture for control of a
type of intelligent lighting not manufactured by Ryger Electronics please use the following steps:
From the main menu select Setup to enter the setup menu:
From the Setup menu select Fixt to set up fixtures:
Select the fixture to be assigned a new type with the 1-16 scanner selection keys and then select a User
type by using the keys. Next select Edit to change the settings for this type. The Edit menu
will be displayed:
Select Pers to alter the personality settings for the fixture type. The display will look similar to the
following:
Lvl corresponds to the level up/down keys. For example level 1 is power, level 2 is colour and so on
as shown on the front panel of the Navigator. DMX shows the fixtures' DMX channel that will be
affected by the level key shown by Lvl. The following should help to explain the setup procedure:
The personality settings for a Ryger TinyScan plus are shown below as a guide for setting up other
fixture types:
4