Insert Editing - JVC GR-AX18EG Instruction Manual

46
EN
REW
STOP
M–0:12:34
LCD monitor or viewfinder
RM-V700U
(provided with GR-AXM28 only)
USING REMOTE CONTROL UNIT (GR-AXM28 only)
COUNTER R/M
PLAY/PAUSE
FF
Power Switch

Insert editing

indicator
Tape counter
START/STOP
REW
PLAY
PAUSE
INSERT
Insert Editing
You can record a new scene into a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio remains unchanged.
NOTE:
Use the RM-V700U remote control unit to perform this
procedure.
SELECT MODE
1
Set the Power Switch to "PLAY".
FIND EDIT-OUT POINT
2
Play back the tape, locate the point and press
PAUSE on the camcorder or the remote control.
RESET COUNTER
3
Press and hold COUNTER R/M for more than
1 second to reset the tape counter, then press again
for less than 1 second and make sure "M" appears.
FIND EDIT-IN POINT
4
Press REW to go a little beyond the beginning of the
scene you want to replace, press PLAY to view the
recorded tape, and press PAUSE exactly at the point
where the new scene should start.
ENGAGE INSERT EDITING MODE
5
Press and hold INSERT, and without releasing
INSERT, press and release PAUSE. The Insert mode
is engaged. When the scene the camcorder is aimed
at appears on the screen, go to the next step.
BEGIN INSERT EDITING
6
Press START/STOP. When the counter reaches
"0:00:00", editing stops automatically and the
camcorder enters the Insert-Pause mode.
END INSERT EDITING
7
Press STOP.
NOTES:
When Insert Editing is performed with the LCD monitor
fully opened, the original audio will be heard from the
speaker.
After step 5, Retake (
The tape may stop slightly before or after the desig-
nated end point, and noise bars may appear. Neither
indicates a defect in the unit.
Only video signal is recorded in the Insert Editing
mode.
pg. 17) can be performed.
(cont.)