Stove Clearances - Jøtul F 3 USA Installation And Operating Instructions Manual

Stove Clearances

Top vent/vertical
Rear heatshield with
Single wall pipe
Rear heatshield with
Double wall pipe or shields
Stove Clearances
Rear Vent/Horizontal
Rear heatshield with
Single wall pipe
Rear heatshield with
Double wall pipe or shields
Connector
Clearances
Singlewall pipe -vertical installations
Double wall pipe-vertical installations
Single wall pipe -horizontal installations
Double wall pipe-horizontal installations
Very important:
Top vent/vertical- assumes the connector pipe is exiting
off the top of the stove and traveling vertically. If top vented
to any horizontal runs –the stove's position is dictated by
the connector pipe clearances.
Rear vent/horizontal- assumes the connector pipe is
existing out the rear of the stove and is traveling
horizontally to the chimney. If rear vented to vertical run –
the stove position is dictated by the connector pipe
clearances.
Dimensions in Inches represent U.S. requirements.
Dimensions in Millimeters represent
requirements.
Wall protection is discussed in further detail on page
10 of this manual.
Jøtul F 3 Clearances
Unprotected Surfaces
Side Rear Corner
24" 25" 18"
610mm 635mm 460mm
18" 10" 14"
460mm 255mm 355mm
Unprotected Surfaces
Side Rear Corner
24" 25" 20"
610mm 635mm 510mm
18" 14" 17"
460mm 355mm 430mm
Unprotected Surface
18" (460mm)
pipe mfgr. listing
18" (460mm)
pipe mfgr. listing
Canadian
USA/Canada
Protected Surfaces
per NFPA 211 or CAN/CSA-B365-M
Side Rear Corner
10" 14" 10"
255mm 355mm 255mm
6" 6" 6"
150mm 150mm 150mm
Protected Surfaces
per NFPA 211 or CAN/CSA-B365-M
Side Rear Corner
10" 25" 18"
255mm 635mm 460mm
6" 6" 6"
150mm 150mm 150mm
Protected Surface
per NFPA 211 or CAN/CSA-B365-M
6" (150mm)
pipe mfgr. listing
9" (230mm)
pipe mfgr. listing
A: Top to Mantel 34"
B: Top to Top Trim 20"
C: Side to Side trim 13"
D: Side to Side Wall 24"
860 mm
510 mm
330 mm
610 mm
11