Two-Piece Shaft; Bevel Gear - Jonsered GC 2125 Operator's Manual
Jonsered brush cutter operator's manual
Hide thumbs
Also See for GC 2125:
- Operator's manual (36 pages) ,
- Operator's manual (32 pages) ,
- Operator's manual (36 pages)
Table of Contents
Advertisement
MAINTENANCE
Two-piece shaft
(GC 2125C)
The drive shaft end in the lower shaft should be lubricated
with grease every 30 hours. There is a risk that the drive shaft
ends (splined coupling) on models with two-piece shafts will
seize if they are not lubricated regularly.
Bevel gear
The bevel gear is filled with the right amount of grease at the
factory. However, before using the machine you should check
that the bevel gear is filled 3/4 full with grease. Use
JONSERED special grease.
The grease in the bevel gear does not normally need to be
changed except if repairs are carried out.
– 25
English
Hide quick links:
Advertisement
Table of Contents
