Thermo Scientific FOCUS GC Instruction Manual page 331

Set-Up
7. When back to main menu, please select
CAUTION Please confirm to make the changes effective, and remember that from now on, the
FOCUS GC LAN will respond to the newly assigned IP Address.
8. Disconnect the FOCUS GC from direct RED patch, and connect it to its final
Instruction Manual
Make sure the Serial port is selected as follows:
Parameter
Baud Rate
Parity
Data Bit
Stop bit
Flow Control
UART FIFO
Press ESC when done, to return to upper level menu
destination LAN environment.
At this point, as a final check, start from the computer that should be used for
controlling the newly installed FOCUS GC and run Command Prompt.
Then type ping xxx.xxx.xxx.xxx, where the xxx.xxx.xxx.xxx is the new IP
you just configured.
The FOCUS GC LAN should answer as follows:
Set To:
38400
None
8
1
RTS/CTS
Enabled
.
Exit
Chapter 16
LAN Option Set-up
331