Permanent Connection - John Lewis JLWM 1604 Instruction Manual

Important! Information on the
electrical connection is given on the
rating plate on the inner edge of the
appliance door.
The appliance is supplied with a 13 amp plug
fitted.
In the event of having to change the fuse in
the plug supplied, a 13 amp ASTA approved
(BS1363/A) fuse must be used.
Should the plug need to be replaced for any
reason, proceed as described below.
The wires in the mains lead are coloured in
accordance with the following code:
1 Green and Yellow - Earth
2 Brown- Live
3 Cord Clamp
4 Blue- Neutral
1
4
The wire coloured green and yellow must
be connected to the terminal marked with
the letter «E» or by the earth symbol
coloured green and yellow.
The wire coloured blue must be connected
to the terminal «N» or coloured black.
The wire coloured brown must be
connected to the terminal marked «L» or
coloured red.
Upon completion there must be no cut, or
stray strands of wire present and the cord
clamp must be secure over the outer sheath.
Note!
When the appliance is installed the power
supply cable must be accessible.

Permanent connection

in the case of permanent connection it is
necessary that you install a double pole
switch between the appliance and the
electricity supply (mains), with a minimum
2
gap of 3 mm between the switch contacts
3
and of a type suitable for the required load
in compliance with the current electrical
regulations.
The switch must not break the yellow and
or
green earth cable at any point.
35
Warning! A cut off plug
inserted into a 13 amp socket is
a serious safety (shock) hazard.
Ensure that the cut off plug is
disposed of safely. Should the
appliance power supply cable
need to be replaced, this must
be carried out by our Service
Force Centre.
The appliance should not be
connected to the electrical
supply by means of an extension
cable.