Delay Start - John Lewis JLWM 1604 Instruction Manual

cycle is very quiet and it can be selected at
night or in times with a more economical
power rate. On some programmes the
rinses will be performed with more water.
If the «Rinse Hold» or «Quiet»
option has been selected the «Door
lock» light is on, the «Start/Pause»
button light goes out and the display
shows a flashing «0». The door
cannot be opened because the water
must be drained. To empty out water
read the paragraph «At the end of
the programme».
3.3 Options: Easy Iron and Extra Rinse
symbols, Prewash, Stain, Intensive
description. If an option is enabled, the icon
or the description is on.
3.4 Wash timemessage:
• Duration of washing programme in
hours and minutes, after you have
selected a programme. While the
programme is running (after you have
pressed the Start/Pause button), the
displayed time value decreases by one
unit every minute.
When selecting the «proportional»
programmes, the display shows the
washing duration of the maximum
recommended load. After the
«Start/Pause» has been pressed, on
the display «Wash time» message
starts flashing to indicate that the
appliance is calculating the laundry
amount and the real duration. During
this time, the washing duration
shown decreases. When the
calculating phase has finished, the
«Wash time» stops flashing. The
washing time is adjusted to the real
load.
• Delay start, a time value indicated in
hours and minutes and selected by
pressing the delay start button. The delay
time (20 hours max) is displayed for a few
seconds, then the duration of the selected
programme reappears. After you have
pressed the Start/Pause button, the
countdown is updated every hour, and,
for the last hour, every minute.
• An alarm code indicates a fault with the
machine (see the relevant chapter).
• An incorrect option selection has
been made: this is indicated by the
message Err for a few seconds when an
option incompatible with the current
programme is selected.
• The washing machine has
completed the programme: this is
indicated by a flashing zero. The «Door
lock» pilot light and the Start/Pause light
go out and the door can be opened.
• The washing machine has stopped
with water in the tub, at the end of
the «Soak» or of a programme with the
«Rinse hold» or «Quiet» option: this is
indicated by a flashing zero. The «Start/
Pause» light goes out but the «Door lock»
pilot light is still on. The door cannot be
opened.
3.5 Quick option. If enabled, the
description is on.
3.6. Delay Start: the description is on if
the Delay start is set.
3.7. Child lock symbol.
11