Listening To Radio - Jensen JMC-1100 Owner's Manual

2. Press the "MEM/CLK-ADJ" button, the first two digits of the time (hours) "00" are flashing.
Press "SKIP DOWN
button to store the correct hour.
3. The third & fourth digits of the time (minutes) "00" are flashing, press the "SKIP DOWN
or UP " button to set the correct minutes. Press "MEM/CLK-ADJ" to store the correct
minutes.
4. To select 12/24 hours display mode, press and hold the CD "STOP" button on main unit and
then press the "MEM/CLK-ADJ " button to switch the clock between 12H (12 Hour) and 24H
(24 Hour).
Note: 1. The pre-set time will need to be reset completely if the main power button on system is
turned off. You are recommended to only switch the system into standby mode for
convenience and also to avoid having to reset the time again.
2. 12/24 hour format mode can only be set by control buttons on the main unit.

LISTENING TO RADIO

Manual Tuning
1. Press the POWER button to turn on the unit.
2. Press "TUNER/BAND" button and select the desired band (AM or FM).
3. Tune to the required radio station by pressing the "TUNING + / -" button on main unit or SKIP
UP / DOWN on remote manually.
4. Adjust volume controls to the desired volume level.
Auto Tuning
1. Press "TUNER/BAND" button and select the desired band (AM or FM).
2. Press and hold the "TUNING + or – " button for 1-2 seconds and then release.
3. The unit will start seeking automatically and stop until a radio station is reached.
4. Repeat step 2-3 until the desired radio station is being reached.
5. Adjust volume controls to the desired volume level.
Preset Radio Stations
You can store up to total of 20 radio stations in the memory.
1. Set to TUNER mode
2. Turn to the desired radio station by "MANUAL" or "AUTO" tuning method.
3. Press "MEM/CLK-ADJ" button to enable program state.
4. Press "REPEAT/M-UP" button to select the desired station memory for storage.
5. Press "MEM/CLK-ADJ" button again to confirm the setting.
6. Repeat step 2 to 5 to store other stations if necessary.
Note:
The pre-set memories will be cancelled completely if switching off the main power button on
1.
system. You are recommended to switch the system into standby mode for convenience
usage.
There are 5 seconds for program state, after 5 sec. this state would release to normal tuner
2.
mode automatically.
You can overwrite a present station by storing another frequency in its place.
3.
Recall the Preset Stations
1. In AM or FM radio mode, press "M-UP" or "M-DN" button to select the preset stations in
order.
FM & FM-Stereo reception
Set the FM mode selector at "MONO" position. Programs are received in mono mode. In
particular when stereo signals are weak. It is preferable to receive the program in mono.
or UP " button to set the correct hour. Press "MEM/CLK-ADJ"
11