Tuner Operation - Jensen MSR3007 Installation And Operation Manual

TUNER OPERATION

1 4 24
POWER
2a
VOLUME
13 MODE +
CAT SEL CAT
2b
VOLUME
1 2 3
MUTE INT
17 18 14 8 6
Select a Band
Press the BAND button (16) to change between three FM bands and two AM (MW) bands.
Manual Tuning
Press the TUNE/TRK >>| or |<< buttons (20, 21) to seek stations up/down step by step.
Auto Seek Tuning
Press and hold the TUNE/TRK >>| or |<< buttons (20, 21) to automatically seek the next or
previous strong station.
Preset Stations
Six numbered preset buttons store and recall stations for each band.
Store a Station
Select a band (if needed), then select a station. Press and hold a preset button (5-10) for two
seconds. The preset number will appear in the display.
Recall a Station
Select a band (if needed). Press a preset button (5-10) to select the corresponding stored
station.
Automatically Store / Preset Scan (AS/PS)
Automatically Store
Select a band (if needed). Press and hold the AS/PS (15) button for more than three seconds
to automatically select six strong stations and store them in the current band. The new stations
replace any stations already stored in that band.
NOTE: During Auto Store (AS), the tuner will default to "Local" mode while scanning the
band initially. After scanning the entire band once, the unit will switch to "Distant" mode
for all subsequent Auto Store tuning.
12 22
23 11 3
EQ AUDIO
MENU
IX BASS
TUNE/TRK
SEEK
INFO
SEEK
SCROLL
TUNE/TRK
BAND
SEARCH
40W x 4
AUX
IN
4 5 6
RPT RDM AS/PS
5 7 9 10 16 15 19
Preset Scan
Select a band (if needed). Press AS/PS (15) to scan stations stored in the current band. The
unit will pause for ten seconds at each preset station. Press AS/PS again to stop scanning
when the desired station is reached.
21
20
6
MSR3007