Safety Instructions - Jenn-Air 720-0163 Use And Care Manual

Stainless steel lp gas grill
Table of Contents

Advertisement

SAFETY INSTRUCTIONS

RECOGNIZED
WARNING
WARNING – Hazards or unsafe
practices which COULD result in severe
personal injury or death.
CAUTION
CAUTION – Hazards or unsafe practices
which COULD result in minor personal
injury.
WARNING
1. Do not store spare liquid propane cylinders under or near this appliance.
2. Never fill the cylinder beyond 80 percent capacity.
3. If the information above is not followed exactly, a fire resulting in death or serious injury
could occur.
WARNING
Never attempt to use damaged or obstructed equipment. See your local liquid propane dealer for
repair.
WARNING
Check all gas supply fittings for leaks before each use
have been checked and do not leak.
Do not smoke while leak testing.
Never leak test with an open flame.
CAUTION
When using the rotisserie burner, remove the
warming rack. High heat from the burner
may cause the warming rack to bend.
WARNING
The rotisserie motor is equipped with a plug and should
be plugged directly into a properly grounded receptacle.
DO NOT cut or remove the grounding prong from this
plug.
Keep the rotisserie motor electric cord away from the
heated surfaces of the grill. When not in use remove and
store the motor in a dry location
SAFETY SYMBOLS, WORDS AND LABELS
WARNING
Do not try lighting this appliance without first reading
the "LIGHTING INSTRUCTIONS" section of this
manual.
WARNING
Spiders and insects can nest inside the burners of
the grill and disrupt gas flow. This very dangerous
condition could cause a fire behind the valve panel,
thereby damaging the grill and making it unsafe for
operation.
Inspect the grill at least twice a year.
.
Do not use the grill until all connections
WARNING
1. Attach the coupling half (socket) to
the gas supply line in accordance
with NFPA54/ANSI Z223.1FUEL gas
code.
2. Prior to inserting the plug, test the
connection for leaks following the
leak test instructions on page 10.
After the leak test is completed, rinse
the connection with clean water to
remove any corrosive residue.
3. Do not use open flame to test for
leaks.
1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents