Loading Setting Data - Sony PMW-500 Operation Manual

side panel and in orange in the card slot
section). A completion message appears and
the ACCESS lamp goes out when the data
has been saved.
If an error message appears
One of the following error messages may appear
during execution of the save, or as soon as you
select [Execute]. In this case, the file is not saved
to the SxS memory card.
Error message
NG:Cannot Save No recordable
NG:Media Full
When using a USB flash drive (in UDF mode)
Connect a formatted USB flash drive (see
page 71) to the external device connector.
Select All Save USB >Execute in step 2.
To assign names to files
Assigning a name before you save data in an ALL
file can make it easier to distinguish your files.
The following characters can be used in file
names.
Alphanumeric characters (a–z, A–Z, 0–9) and
special characters ( ! # $ % & ' ( ) * + , - . / : ; < =
> ? @ [ \ ] ~)
1
Select FILE >All >File ID in the setup
menu.
2
Turn the MENU knob to select a
character, and then press the MENU
knob.
3
Repeat step 3.
4
When you have finished entering
characters, press the MENU knob to
move the cursor to "SET", and then
press the MENU knob.
The specified name is displayed.
When you save the file (see page 159), the
data will be saved under this name.
160 Saving and Loading Settings
Problem What to do
Insert
media is recordable
inserted. media.
The media is Use media with
full. free capacity
remaining.

Loading Setting Data

Note
When you load a file from an SxS memory card or a USB
flash drive (in UDF mode), the data saved in the
camcorder's internal memory is overwritten.
See "Basic Setup Menu Operations" (page 107) for
information about menu operations.
1
Select FILE >All in the setup menu.
2
Select All Load SxS >Execute.
A list box of ALL files appears.
File numbers where "No File" is displayed
are empty file numbers. File numbers with a
file name or a date and time are the number
of files that already contain data.
3
Turn the MENU knob to select the
desired file number.
4
Press the MENU knob.
A confirmation message appears.
5
To execute the load, select [Execute],
and then press the MENU knob.
To cancel the load, select [Cancel], and
then press the MENU knob.
If you choose to execute the load, the
ACCESS lamp lights (in blue on the right-
side panel and in orange in the card slot
section). The ACCESS lamp goes out and a
completion message appears when the data
has been loaded.
If an error message appears
One of the following error messages may appear
during execution of the load, or as soon as you
select [Execute]. In this case, the file is not loaded
from the SxS memory card.
Error message Problem
NG:No Data • There is no
readable media
• The specified
file does not
exist on the
media
When using a USB flash drive (in UDF mode)
Connect a formatted USB flash drive (see
page 71) to the external device connector.
Select All Load USB >Execute in step 2.
What to do
Insert the
media that
contains the
file you want.