Table of Contents
Advertisement
Section 7
Changing the Electrical Downtilt on a Group of
Antennas
In addition to changing the downtilt of a single antenna, changes may also be applied to a
group of antennas. The list of antennas that make up the group is defined by three configuration
parameters – Sector ID, Minimum Electrical Tilt, and Maximum Electrical Tilt. Only antennas
that are identical in all three parameters are candidates for a given group move.
1. Select a device from the 'Device Information' list that contains the Sector ID and tilt range
representing the group to be moved (Figure 7-1).
2. Click 'Move Sector' (Figure 7-1).
3. From the 'Set Electrical Tilt for Sector' screen, notice that the selected device is highlighted
and displayed in the box labeled 'Antennas Included In Move'. This box displays a list
of all devices that will be included in the sector move. Initially, this box contains only the
antenna that was selected from the main screen. All of the current configuration settings
for this device, including its current tilt, are displayed on this screen (Figure 7-2).
1. Click on device within sector to select sector for tilt move.
Bulletin 639510
2. Click 'Move Sector'.
Figure 7-1. Selecting an Antenna Within a Sector.
May 2005
7-1
Advertisement
Table of Contents
