Rolled Hem; Cording - Janome MEMORY CRAFT 4900 QC Instruction Book

q w
1
q w
32
e
0.5 cm
0.8 cm
e
q

Rolled hem

Machine settings
q Pattern:
w Presser foot:
e Thread tension:
To sew:
Fold the edge of the fabric twice, 6 cm (2 3/8˝) in length
and 0.3 cm (1/8˝) in width.
Trim the corner 0.5 cm (3/16˝) by 0.8 cm (1/4˝) for
easier insertion of the hem into the foot.
Position the fabric aligning the edge of hem with the
guide on the foot.
Lower the foot and sew 1–2 cm (1/2˝ – 1˝) while pulling
both threads to the back.
Stop the machine with the needle down in the fabric.
Raise the foot and insert the folded portion of the fabric
into the curl of the foot.
Lower the foot, and then sew by lifting up the edge of
the fabric to keep it feeding smoothly and evenly.

Cording

Machine settings
q Pattern:
w Presser foot:
e Thread tension:
Attach the cording foot H
3-strand cording
Insert 3 strands of cording under the spring of the foot
and draw them under the foot to the rear.
Hold the three strands parallel for even sewing and be
sure to sew over the strands
Stitch slowly and smoothly, guiding the fabric as you
sew.
q Spring
1-strand cording
Insert 1 strand of cording under the spring of the foot
and draw it under the foot to the rear (use the center slot
of the spring).
Select pattern 8 (mode 1), then decrease the stitch
width and sew.
6 2
1 (mode 1)
Hemmer foot D
AUTO
32 (mode 2)
Cording foot H
AUTO