Ives Offset Intermediate Pivot 7212/12V Installation Instructions

3/4" Offset Intermediate Pivot
Right hand
installation
1. Prepare and mortise hinge stile of door and hinge side jamb to receive pivot set. Determine
pivot location using dimensions on reverse side. The pivots are handed and must match hand
of door. To determine hand of door and proper pivot position, see diagrams above. Install top
and bottom pivot sets before installing intermediate pivot.
2. Locate, drill, and tap 1/4-20 mounting holes for metal door. Locate and drill pilot holes for
#14 wood screws for wood door. Then hang door.
3. Open door about 90°. Install pivot leafs with 1/4-20 x 3/4" FHMS or #14 FHWS screws provided.
4. The door weight should be balanced between bottom and intermediate pivots. To adjust
intermediate pivot (refer to diagram above):
A. Loosen set screw in jamb leaf with 3/32" Allen wrench.
B. Insert 5/32" Allen wrench through jamb leaf pivot and into underside of bearing spindle.
C. Turn clockwise until door weight is balanced evenly with bottom pivot.
D. Tighten 3/32" set screw securely.
!
Improper pivot set installation can lead to personal injury or property damage. Follow
all instructions carefully. For questions contact Technical Support at 1-888-371-7331.
13103 Rev. 4 © 2006 Ingersoll-Rand Company Limited

Installation Instructions

7212/12V and 7222
Door
leaf
Frame
leaf
CAUTION
Bearing
spindle
installation shown;
left hand opposite
3/32" Allen
wrench
3/32" set screw
5/32" Allen
wrench
Right hand
Left hand
installation