IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY D WALT TOOL, your nearest DeWALT service center call (AUS) 1800 654 155 or (NZ) 09 526 2556 or go to www.dewalt.com.au on the Internet. CALL US AT: 1800 654 155 (Aust) or 09 526 2556 (NZ).
• Replacement of the supply cord. If the supply cord is damaged, it must be • crystalline silica from bricks and cement and other masonry products, and replaced by the manufacturer or an authorised DeWALT Service Centre in order • arsenic and chromium from chemically-treated lumber (CCA).
WARNING: Batteries can explode, or leak, and can cause injury or fire. To reduce this risk: The DW086-XE and DW087-XE lasers are self-leveling laser tools that can be used • Carefully follow all instructions and warnings on the battery label inside and outside for horizontal (level) and vertical (plumb, DW087-XE model only) and package.
To Turn the Lasers On and Off (Fig. 2) smooth, flat surface. DW086-XE: With the laser off, place it on a flat surface. Press the ON/OFF button (C) • Always mark the center of the beam created by the laser.
Page 7
654 155 or (NZ) 09 526 2556. See our catalog on the World Wide Web at www. dewalt.com.au. The DW086-XE and DW087-XE lasers are designed to self-level. If the laser has been tilted so much that it cannot level itself (average > 4° tilt), it will flash the laser beam USING THE PIVOT BRACKET (FIG.
LEVELING THE LASERS As long as the DW086-XE and DW087-XE lasers are properly calibrated, the lasers are self-leveling. Each laser is calibrated at the factory to find level as long as it is positioned on a flat surface within average ±...
Page 9
FIG. 7 Step 1, 2 9m (30') Step 3 Step 3 Steps 4, 5 Step 8 Step 7 Step 6 1. Attach the laser to one end of a wall using its pivot bracket. Distance Allowable Distance 2. Turn on the laser’s horizontal beam and pivot the laser toward the opposite end Between Walls Between Marks of the wall and approximately parallel to the adjacent wall.
4. Mark the position of the laser beam on the ceiling (f). Mark the center of the The DW086-XE and DW087-XE have been designed to self-level up to an average laser beam directly over the midpoint of the line on the floor.
(AUS) 1800 654 155 or (NZ) 09 526 2556 for a free replacement. by unqualified personnel may result in a risk of injury. To locate your nearest D WALT service center call (AUS) 1800 654 155 or (NZ) 09 526 2556 or go to www.dewalt. com.au on the Internet. Guarantee Applicable to hand held Power Tools, Lasers and Nailers.