Oven Racks - GE Monogram ZDP486ND Technical Service Manual
Professional range and rangetops
Hide thumbs
Also See for Monogram ZDP486ND:
- Owner's manual (128 pages) ,
- Installation instructions manual (68 pages) ,
- Installation instructions manual (68 pages)
Table of Contents
Advertisement
Oven Racks
WARNING: To avoid possible burns, remove or install
the racks before turning on the oven.
To remove a rack:
1. Make sure the rack is pushed all the way into
the oven.
2. Grasp the rack by both its upper front rail and its
lower front rail and lift straight up to unlock the
front rack locks from the rack supports.
Lift to unlock front
rack locks from
the rack support
Lower
front rail
Upper
front rail
Front rack lock
3. Firmly holding onto both the upper and lower
front rack rails, pull the rack forward and
remove it from the oven.
Lower
front rail
Upper
front rail
To install a rack:
1. Place the rear rack locks over and onto the
rack supports. (Five rack positions are available,
including the top position.)
2. Slide the rack all the way in until the rear rack
locks are secure on the rear rack supports, and
press the front rack locks onto the front rack
supports.
Front rack
lock
Slide the rack all the way in
and push down to lock the
front rack locks onto the
front rack supports
3. Pull the rack all the way out to check that it is
properly engaged.
Care and Cleaning
Note:
•
The racks may remain in the oven during the
self-cleaning cycle without being damaged.
•
Periodically, after several self-clean cycles, the
oven racks may need to be lubricated using the
graphite lubrication shipped with the wall oven.
To order additional graphite lubrication, call
our National Parts Center at 800.626.2002 and
reference WB02T10303.
Lubricating an oven rack:
1.
Remove rack from the oven.
(Continued next page)
Page 54
Hide quick links:
Advertisement
Table of Contents
