Invacare Neck Support Installation & Operating Instructions

NECK SUPPORT

SAFETY SUMMARY

WARNING
DO NOT install this equipment without first read-
ing and understanding this instruction sheet. If you
are unable to understand the se instructions, con-
tact a healthcare professional, dealer, technical
personnel if applicable before attempting to in-
stall this equipment - otherwise, injury or damage
may occur.
ATTACHING THE NECK SUPPORT
(FIGURES 1 AND 2)
Curved Back
1. Remove neck support bracket from packaging.
2. Unzip back cover on both sides of center panel.
3. Lift center panel.
NOTE: If a NEW neck support is used on an EXISTING
Curved Back than the adapter plate and support bracket
MUST be used.
NOTE: If a NEW neck support is used on a NEW Curved
Back than the support bracket can be used WITHOUT
the adapter plate.
4. Perform Steps 4a. and 4b. or 4c.:
a. Secure neck adapter plate to the back shell
with the four (4) mounting screws provided (If
applicable).
b. Then secure the neck support bracket to the
neck adapter plate using the two (2) mounting
screws provided.
c. Secure the vertical neck post to the back shell
using the two (2) mounting screws provided.
5. Close center panel with the vertical neck post ex-
posed through the slot provided in upholstery.
6. Zip the back cover closed.
7. Insert horizontal post into vertical post and secure
with thumbscrew knob.
8. Insert vertical post into neck support bracket.
9. Secure with a thumbscrew knob or adjustable lever.
10. Insert detent pin into through both walls of vertical
post (Transport Ready Option [TRRO]).
11. If adjustment is required, refer to ADJUSTING THE
NECK SUPPORT in this instruction sheet.
Assembly, Installation, and Operating Instructions
Center Panel (STEP 3)
Curved Back
Neck Support Bracket
Neck Support Assembly (STEP 8)
Horizontal
Post (STEP 7)
Vertical Post
(STEP 7)
Neck Support Bracket (STEP 8)
NOTE: Ensure that the retaining screw is located
in the end of the horizontal post.
Horizontal Post
Vertical Post
Neck Support
Bracket
Detent Pin
NOTE: Neck Adapter Plate NOT shown.
FIGURE 1 - FIGURE 1 - FIGURE 1 - FIGURE 1 - A A A A A T T T T T T T T T TA A A A A CHING FIGURE 1 - CHING CHING CHING THE NECK SUPPOR CHING
ON ON THE CUR ON THE CUR THE CURVED B THE CUR
ON ON THE CUR
1
Mounting
Screws
(STEP 4)
Thumbscrew
Knob (STEP 7)
Curved Back
Thumbscrew
Knob (STEP 9)
Thumbscrew Knob
Depth
Adjustment
Retaining
Screw
Height
Adjustment
Stop
Height
Adjustment
Adjustment Lever
THE NECK SUPPOR THE NECK SUPPOR THE NECK SUPPOR THE NECK SUPPORT T T T T
VED BA A A A A C K VED B VED B C K C K C K
VED B C K