Radio Shack 15-1950 Owner's Manual

9KTGNGUU"+4"4GOQVG"'ZVGPFGT
15-1950
#
"+/2146#06"
If an icon appears at the end of a paragraph,
go to the box on that page with the
corresponding icon for pertinent information.
Rý
#
— Warning
° ° ° °
. . . .
— Caution
±
— Note
WARNING:
To reduce the risk of fire or shock hazard, do not expose this
product to rain or moisture.
.. ..
CAUTION:
CAUTION
RISK OF ELECTRIC SHOCK, DO
!
NOT REMOVE COVER OR BACK.
RISK OF ELECTRIC NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO
SHOCK DO NOT OPEN
QUALIFIED PERSONNEL.
The lightning symbol is intended to
alert you to the presence of uninsulated
!
dangerous voltage within this
product's enclosure that might be of
sufficient magnitude to constitute a risk of electric
included in the literature accompanying
shock. Do not open the product's case.
this product.
(%%"&'%.#4#6+10"
1("%10(14/+6;
This device complies with Part 15 of the
FCC Rules . Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Product: Wireless IR Remote
Extender
Model: 15-1950
Responsible RadioShack
Party: 100 Throckmorton
Fort Worth, TX 76102
Phone: 817-415-3200
.
"%#76+10"
You must use a Class 2 power
! source that supplies 12V DC and
delivers at least 120 mA. Its cen-
ter tip must be set to positive and its plug
must fit the receiver's DC 12V jack. The
supplied adapter meets these specifi-
cations. Using an adapter that does not
meet these specifications could damage the
receiver or the adapter.
• Always connect the AC adapter to the
receiver before you connect it to AC power.
When you finish, disconnect the adapter
from AC power before you disconnect it
from the receiver.
Thank you for buying the RadioShack
#
Wireless IR Remote Extender, which
extends your existing remote control's
operating range. The extender lets you
control your TV, VCR, stereo, CD player, or
— Important
cable converter from a greater distance than
— Hint
any of your existing remote controls. You
need not worry about line-of-sight
requirements.
Your extender includes a transmitter and a
TO REDUCE THE
receiver. The transmitter senses the infrared
signals from your audio/video equipment's
The exclamation symbol is
remote controls and converts them into
intended to inform you that
important operating and
maintenance instructions are
wireless transmissions. The receiver senses
these transmissions, converts them back
into identical infrared signals, then relays
them to your audio/video equipment.
+056#..#6+10
+
056#..+0)
1. Place the receiver in front of the audio/
.
video equipment and position it:
• within 20 feet (6.1 meters) of the
audio/video equipment's remote
sensor
• where the front of the receiver
directly faces the audio/video
equipment's remote sensor
The first time you use the extender,
rotate and adjust the receiver's
telescoping antenna until you get the
best reception.
OWNER'S MANUAL — Please read before using this equipment.
" "4 "
6*' '%'+8'4
©
2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
Full Remote Control Compatibility 
receives, converts, and relays infrared
signals from virtually any infrared remote
control.
Powerful Radio Frequency  lets you
control audio/video equipment from
anywhere in your house, up to 100 feet (30.5
meters) away.
2. Fully extend the telescoping antenna.
You can easily identify the receiver or
transmitter from the label pasted on the
bottom of the product. The receiver is
equipped with and
DC 12V
and the transmitter is equipped with one
jack.
DC 12V
3. Connect the supplied AC adapter's
barrel plug into the receiver's
jack, then connect the adapter's AC
plug to a standard AC outlet.
jacks,
IR OUT
DC 12V
. . . .