Invacare Auriga10 User Manual page 43

The Invacare® Auriga/Auriga
is located on the front of the Battery and Motor Compartment Cover (1). To charge the scooter, you
only need to connect it to a mains power supply using the cable supplied with the scooter.
Connecting the scooter to a mains power
supply
First connect the cable to the scooter.
Then connect the cable to the mains power
supply and switch on.
Disconnecting the scooter from the mains
power supply
First disconnect the cable from the mains
power supply.
Then disconnect the cable from the scooter.
How can I tell when the batteries are fully charged?
Look through the slot for the de-clutching lever (2) down into the motor and battery compartment.
You will see a green LED. This is the charger LED.
LED ACTIVITY
LED lights contantly
LED dims and flickers
LED go out / flickers for a few seconds /
goes out again
10 is equipped with an integrated charger. The socket for this charger
CHARGING PHASE
Start
90% Finished
Finished
43