Stiga MULTICLIP 51S Instruction Manual
Hide thumbs
Also See for MULTICLIP 51S:
- Användningsinstruktioner (14 pages) ,
- Instructions for use manual (8 pages) ,
- Gebrauchsanleitung (13 pages)
Advertisement
Table of Contents
- 1 Using the Mower
- 2 Before Starting
- 3 Start of Engine
- 4 Starting the Engine
- 5 Maintenance
- 6 Mowing Tips
- 7 Cooling System
- 8 Cutting Height
- 9 Changing Oil
- 10 Air Filter
- 11 Sparking Plug
- 12 Adjusting the Clutch Cable
- 13 Adjusting Drive Belt
- 14 Shock Absorber
- 15 Changing Blades
- 16 Winter Storage
- Download this manual
See also:
Instructions for Use Manual
Advertisement
Table of Contents
Related Manuals for Stiga MULTICLIP 51S
Summary of Contents for Stiga MULTICLIP 51S
- Page 1 DEUTSCH MULTICLIP 8211-0224-08...
- Page 2 SVENSKA...
- Page 3 7. Briggs & Stratton LS 45 0,15 l. 8. Briggs & Stratton XTE 50 9. Briggs & Stratton INTEK 10. Briggs & Stratton LS 45 11. Briggs & Stratton XTE 50 12. Honda 13. Multiclip 48/Pro 48, Briggs & Stratton...
- Page 4 SVENSKA 14. Multiclip 51S, Briggs & Stratton 15. Multiclip 51SE 16. Multiclip 48, Honda 17. Multiclip 51S, Honda 18. Pro 51S 20. Multiclip 51S/51SE/PRO 51S 21. Briggs & Stratton LS 45...
- Page 5 SVENSKA 22. Briggs & Stratton XTE 50 / INTEK 23. Honda Briggs & Stratton : 0,76 mm 0,75 mm Honda: 0,7-0,8 mm 25. Multiclip 51S/51SE 26. PRO 51S 27. Multiclip 51S, 51SE, PRO 51S 40 Nm 28. PRO 48, PRO 51S...
-
Page 6: Using The Mower
ENGLISH If necessary the upper part can be turned to one SYMBOLS side to facilitate mowing close up to walls etc (fig. 4). The following symbols are displayed on the ma- WIRE BRACKET chine in order to remind you about the safety pre- cautions and attention necessary when using the Fit the wire bracket using the nut and bolt (fig. -
Page 7: Start Of Engine
ENGLISH Note! Bear in mind that petrol is a perishable, do 5. Move the throttle control N to the chokeposi- not purchase more petrol than can be used within tion . Note! Don't use the choke position 30 days. when the engine is warm (fig. 16, 17). START OF ENGINE 6. -
Page 8: Maintenance
ENGLISH 2. Release Start/Stop-loop G to stop the engine MAINTENANCE (fig. 13, 14, 15, 16, 17, 18). This loop must not be disengaged (e.g. through fixing it in the de- No service is to be made on the motor or pressed position against the steering), as the en- grass cutter unit without first switching gine cannot be stopped. -
Page 9: Air Filter
ENGLISH Fill with new oil: use oil of SAE 30 or SAE 10W- on the battery and put on charge for 24 hours. On 30 quality. The crankcase holds approx. 0.6 litre. completion of charging, connect the battery termi- Fill until the oil reaches the “FULL/MAX” mark nal to the terminal on the motor. -
Page 10: Adjusting Drive Belt
To replace the blade, slacken the screw (fig. 29). 3. In this position the spring H should then be ex- Fit the new blade so that the stamped STIGA log- tended 6 mm from it's unloaded position to give otype is turned facing the blade attachment (and a sufficent lockforce in the transmission. -
Page 11: Winter Storage
ENGLISH STORAGE WINTER STORAGE Empty the fuel tank. Start the engine and let it run until it stops. The same petrol must not remain in the tank for more than one month. Tip up the mower and screw out the sparking plug. Pour a teaspoon of engine oil in the sparking plug hole.