Table of Contents
Advertisement
FRAME
AXLE TUBE POSITIONS
AXLE
TELESCOPING
POSITION
TUBE HOLE
TOP
A
B
Telescoping
Tube
MIDDLE
B
C
Telescoping
Tube
BOTTOM
A
B
Telescoping
Tube
NOTE: Suspension telescoping tubes and tabs shown.
Non-suspension telescoping tubes and anti-tipper sock-
ets are not shown for clarity.
* NOTE: When viewed from the front of the wheelchair,
inside of the rear wheels, an inverted camber clamp has
the tab or anti-tipper socket at the top of the axle tube.
Refer to DETAIL "A" of FIGURE 14.
DETAIL "B" - MOUNTING HOLE PATTERN
Telescoping Tube
Hole A
Hole B
Hole C
Hole 1
Hole 2
Tab
Metal Tabs
FIGURE 15 - REPOSITIONING THE AXLE TUBE
CLAMP
CLAMP
HOLE
POSITION*
1
STANDARD
2
Camber
Clamp
Tab DOWN
1
STANDARD
2
Camber
Clamp
Tab DOWN
2
INVERTED
1
Tab UP
Camber
Clamp
Camber
Clamp
29
REPOSITIONING QUICK RELEASE
LEVERS (FIGURE 16)
NOTE: This procedure should only be performed if quick
release levers are on top of the axle mounting tube and
interfere with the desired rear seat-to-floor adjustment.
This procedure will position the quick release lever on
the bottom of the axle tube.
1. Remove the threaded knob from the quick release
lever.
2. Remove the quick release lever, recessed washer
and coved washer from the camber clamp.
3. If necessary, position the recessed washer and coved
washer onto the quick release lever, as shown in
FIGURE 16.
4. Insert the quick release lever with washers through
the camber clamp as shown in FIGURE 16.
5. Secure the quick release lever to the camber clamp
with the threaded knob.
6. Repeat for opposite quick release lever.
Quick Release Lever
SIDE VIEW OF CAMBER CLAMP WITH QUICK
RELEASE LEVER
LEVER ON
CLAMP TOP
FIGURE 16 - REPOSITIONING QUICK RELEASE LEVERS
PROCEDURE 4
Recessed
Washer and
Coved Washer
Camber
Clamp
Threaded
Knob
LEVER ON
CLAMP BOTTOM
F
R
A
M
E
Advertisement
Table of Contents
