Audio Adjust Functions - Integra DTR-5.8 Instruction Manual

Advanced Setup—Continued

Audio Adjust Functions

Here you can set listening mode-related settings and
functions.
1 Press the [Receiver] button fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "3. Audio
Adjust," and then press [Enter].
The Audio Adjust menu appears.
3
Use the Up and Down [ ]/[ ]
buttons to select the functions,
and then press [Enter].
The function menu you selected
appears.
4
Use the Up and Down [
buttons to select the settings,
and use the Left and Right [
[
The settings are explained below.
5
When you've finished, press the
[Setup] button.
The setup menu closes.
Note:
This procedure can also be performed on the AV receiver
by using its [Setup] button, arrow buttons, and [Enter]
button.
74
3. Audio Adjust
1. Tone Control
2. Multiplex/Mono
3. PL II x/Neo:6
4. Dolby EX
5. Theater-Dimensional
] buttons to set them.
The Audio Adjust functions are explained below.
Tone Control Settings
You can adjust the bass and treble for the front speakers,
except when the Direct listening mode is selected.
■ Front Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 2 dB steps.
■ Front Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10 dB in 2 dB steps.
Input Channel Settings
]/[ ]
■ Multiplex Input Ch
This setting determines which channel is output from a
stereo multiplex source. Use it to select audio channels
or languages with multiplex sources, multilingual TV
broadcasts, and so on.
Main: The main channel is output (default).
Sub: The sub channel is output.
Main/Sub: Both the main and sub channels are output.
■ Mono Input Ch
This setting specifies the channel to be used for playing
any 2-channel digital source such as Dolby Digital, or 2-
channel analog/PCM source in the Mono listening
mode.
L+R: Both the left and right channels are output
L: Only the left channel is output.
R: Only the right channel is output.
]/[ ]
]/
(default).