Changing The Input Display; Speaker Settings - Integra DTR-5.8 Instruction Manual

First Time Setup—Continued

Changing the Input Display

If you connect an -capable Integra MiniDisc
recorder, CD recorder, or RI Dock to the TAPE IN/OUT
or GAME/TV IN jacks, for
must change this setting.
This setting can only be changed on the AV receiver.
1, 2
iPod photo: If you're using an iPod photo with the
DS-A1 Remote Interactive Dock, connect the DS-A1 to
the GAME/TV IN jacks.
1 Press the [Tape] or [Game/TV]
input selector button so that
"TAPE" or "GAME/TV" appears
on the display.
2
Press and hold down the [Tape]
or [Game/TV] input selector but-
ton (about 3 seconds) to change
the setting.
Repeat this step to select MD, CDR, or
Dock.
For the Tape input selector, the setting
changes in this order:
TAPE
For the Game/TV input selector, the
setting changes in this order:
GAME/TV
Note:
Dock can be selected for the Tape input selector or
Game/TV input selector, but not both at the same time.
to work properly, you
1, 2
MD CDR DOCK
DOCK

Speaker Settings

If you change these settings, you must run the auto-
matic speaker setup again (see page 41).
If the impedance of any speaker is 4 ohms or more but
less than 6, set the minimum speaker impedance to 4
ohms (not North American model).
If you've connected your front speakers to the FRONT
and SURR BACK terminal posts for bi-amping, you
must change the Speaker Type setting. For hookup infor-
mation, see "Bi-amping the Front Speakers" on page 21.
Notes:
• When bi-amping is used, the AV receiver is able to
drive up to 5.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "2. Speaker
Setup," and then press [Enter].
The Speaker Setup menu appears.
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
3
Use the Up and Down [
buttons to select "1. Speaker Set-
tings," and then press [Enter].
The Speaker Settings menu appears.
2–1. Speaker Settings
Speakers Impedance
Speakers Type
]/[ ]
]/[ ]
6 ohms
Normal
51