Integra DTR-5.8 Instruction Manual page 45

First Time Setup—Continued
Reviewing the Results
Use the Up and Down [
buttons to select the settings that
you want to review, and then
press [Enter].
Save
Review SP Config
Review SP Distance
Review SP Level
Cancel
The options are:
Review SP Config:
Review the speaker configuration
settings.
Subwoofer
Front
Center
Surround
Surr Back
Surr Back Ch
Review SP Distance:
Review the speaker distance set-
tings.
Front
Center
Surr Right
Surr Back R
Surr Back L
Surr Left
Subwoofer
Review SP Level:
Review the speaker level settings.
Left
Center
Right
Surr Right
Surr Back R
Surr Back L
Surr Left
Subwoofer
Press the [Return] button to return to
the previous menu.
]/[ ]
Auto Speaker Setup
AUDYSSEY
Auto Speaker Setup
AUDYSSEY
Review SP Config
: Yes
: Full Band
: 80Hz
: 100Hz
: 150Hz
: 2ch
Auto Speaker Setup
AUDYSSEY
Review SP Distance
: 15.0ft
: 15.0ft
: 7.0ft
: 7.0ft
: 7.0ft
: 7.0ft
: 15.0ft
Auto Speaker Setup
AUDYSSEY
Review SP Level
: +12.0dB
: 0.0dB
: -12.0dB
: +3.0dB
: +4.0dB
: -6.0dB
: -3.0dB
: 0.0dB
Changing the Speaker Settings Manually
In some situations, the measurements taken by the auto-
matic speaker setup may not provide usable results. If
running the speaker setup a second time still doesn't pro-
vide usable results, you'll have to set the speaker settings
manually (see pages 68–73).
Using a Powered Subwoofer
If you're using a powered subwoofer, because it outputs
very low-frequency sound and its position is usually low,
it may not be detected by the automatic speaker setup. If
the subwoofer (SW) appears on the SP Detect Result
screen as "No," increase the subwoofer's volume to the
half-way point, set it to its highest crossover frequency,
and then try running the automatic speaker setup again.
Note that if the volume is set too high and the sound dis-
torts, it may not be detected, so use an appropriate vol-
ume level. If the subwoofer has a low-pass filter switch,
set it to Off or Direct. Refer to your subwoofer's instruc-
tion manual for details.
45