Turning On The Av Receiver; Connecting The Power Cord; Turning On And Standby - Integra DTR-5.8 Instruction Manual

Turning On the AV Receiver

Standby/On
Standby indicator

Connecting the Power Cord

• Connect the AV receiver's power cord to a suitable wall outlet.
Notes:
• Before connecting the power cord, connect all of your speakers and AV components.
• Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment
on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.

Turning On and Standby

1
AV receiver
controller
or
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here's a few easy steps to help you configure the AV receiver before you use it for the
very first time. These settings only need to be made once.
■ Do the automatic speaker setup—this is essential!
See "Automatic Speaker Setup (Audyssey 2EQ)" on page 41.
■ Have you connected a component to an HDMI input,
component video input, or digital audio input?
If you have, see "HDMI Input Setup" on page 48, "Component Video
Setup" on page 49, or "Digital Input Setup" on page 50 respectively.
■ Have you connected an Integra MD recorder, CD recorder,
or RI Dock?
If you have, see "Changing the Input Display" on page 51.
40
Press the [Standby/On] button.
Alternatively, press the remote controller's [Receiver] button, followed by
Remote
the [Standby/On] button.
The AV receiver comes on, the display lights up, and the Standby indicator goes off.
To turn the AV receiver off, press the [Standby/On] button, or press the remote control-
ler's [Standby/On] button. The AV receiver will enter Standby mode. To prevent any
loud surprises when you turn on the AV receiver, always turn down the volume before
you turn it off.
Receiver
Standby/On
HDMI
OUT IN
CD recorder, MD recorder,
TAPE
RI Dock