Y AN AUTHORIZED AND CERTIFIED UTHORIZED AND CERTIFIED UTHORIZED AND CERTIFIED DEALER DEALER DEALER DEALER DEALER..For the nearest authorized and certified dealer, call Stanley Hydraulic Tools at one of the loca- tions listed on the back of this manual.
Operation Manual furnished with the power unit. GENERAL SAFETY PRECAUTIONS The HP1 Compact Hydraulic Power Unit will provide safe and dependable service if operated in accor- dance with the instructions given in this manual. Read and understand this manual and any stickers and tags attached to the Power Unit.
• Always wear appropriate safety equipment such as goggles, ear protection, and toe guards. Certain tools used in conjunction with the power unit may require other safety equipment such as breathing filters. • Keep clear of hot engine exhaust. • Do not add fuel to the power unit while the power unit is running or is still hot. •...
LOCAL SAFETY REGULATIONS Enter any local safety regulations here. Keep these instructions in an area accessible to the operator and maintenance personnel.
USE ONLY PARTS AND REPAIR USE ONLY PARTS AND REPAIR PROCEDURES APPROVED BY PROCEDURES APPROVED BY STANLEY AND DESCRIBED IN THE STANLEY AND DESCRIBED IN THE OPERATION MANUAL. OPERATION MANUAL. TAG TO BE REMOVED ONLY BY TAG TO BE REMOVED ONLY BY TOOL OPERATOR.
Hoses listed above are conductive and must never be used near electrical conductors. To help ensure your safety, the following DANGER tags are attached to all hose purchased from Stanley. DO NOT REMOVE THESE TAGS. If the information on a tag is illegible because of wear or damage, replace the tag immediately. A new tag may be obtained at no charge from your Stanley Distributor.
1. ENGINE CRANKCASE OIL LEVEL biological growth that may occur in cool operating hydraulic circuits. These fluids are recommended by Stanley. Other fluids that meet or exceed the specifications of these fluids may also be used. IMPORTANT Chevron AW-MV-32 Do not start the Engine with the Exxon "Univis"...
quick disconnect fittings (NPT type threads). (See Figure 1.) CONTROL PANEL Longer hoses may be used when necessary, but can effect the operation of the engine automatic throttle due to fluid resistance in the hose. If small diameter or long hoses are PRESSURE used, or if restrictive fittings are connected to RETURN...
BASE Do not charge the battery with a standard automotive battery charger. This type of charger produces a charging amperage CYLINDER higher than 2 amps. Charging the GOVERNOR LEVER LEVER battery with amperage higher than 2 amps will damage the battery. FASPIN AUTO 6.
RETURN PRESSURE HOSE HOSE 3. If automatic throttle operation is not HP1 COMPACT POWER UNIT desired, change the throttle control to "5 or 8". PRESSURE QUICK RETURN QUICK SHUTDOWN DISCONNECT DISCONNECT Figure 3.
ROUTINE MAINTENANCE ENGINE MAINTENANCE avoiding the water at the bottom of the con- tainer. Follow the maintenance schedule and general maintenance instructions in the engine mainte- • Each day, check hydraulic lines and fittings for nance and operation manual furnished with the leaks, kinks, etc.