INSTRUCTION MANUAL AUTO CHARGE DUAL AUTOMATIC DUAL OUTPUT BATTERY CHARGER MODEL #: 091-145-12 INPUT: 120 Volt, 50/60 Hz, 3.5 Amps OUTPUT BAT 1: 10 Amps OUTPUT BAT 2: 10 Amps File: IM_091-145-12_revb.indd Rev: B scan using your mobile Revised By: MFG 3 YEAR WARRANTY device for more information Date: 3-25-2014...
IMPORTANT SAFETY INSTRUCTIONS I. PERSONAL PRECAUTIONS: 1. Someone should be within range of your voice or close enough to come to your aid when you work near a lead-acid battery. 2. Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes. 3.
Page 3
INTRODUCTION The Auto Charge Dual is a compact, completely automatic dual output battery charger designed spe- cifically for installations that require 24 volts for starting and 12 volts for accessories. The two batteries are connected in series to obtain 24 volts and the output of each charger is connected to each battery. Each output of the charger is individually controlled to charge it’s particular battery and is electrically isolated from the other.
WIRING I. BATTERY CHARGER WIRING INSTRUCTIONS 1. Refer to Installation Wiring Diagrams I and II. 2. Refer to Wiring Specifications to determine the recommended wire size and maximum lengths. Using a smaller gauge may cause overheating of the terminal. Additional information is available upon request if longer, larger wiring is required.
INSTALLATION WIRING DIAGRAM I. FOR 2 INDIVIDUAL BATTERIES Wiring Diagram shown is for a 10 foot installation 170 Cherry Avenue Ph: 800-346-0857 West Sayville, NY 11796 Fax: 631-567-5826 www.kussmaul.com sales@kussmaul.com...
Page 6
II. FOR 24 VOLT STARTER AND 12 VOLT ACCESSRIES Wiring Diagram shown is for a 10 foot installation The Series connection of the two 12 volt batteries produces 24 volts. Each battery is individually charged at 12volts. Even though the batteries may supply different loads, each battery is automaticl- ly supplied with the correct charging current.
SPECIFICATIONS Input Power: 120 Volt, 50/60 Hz, 3.5 Amperes Input Voltage Range: 105-132 VAC Input Current Max (@132 VAC): 5 Amps Inrush Current: 7 Amps Input Fuse: 8 Ampere, fast acting Output Power - Bat 1 & Bat 2: 12 Volts DC, 20 Amperes Max, Total Output Output Voltage (No Load): 13.25 VDC (per output) Output Voltage Tolerance (No Load): +/- 0.4% Output Voltage (Full Load): 13.12 VDC...
VEHICLE OWNER _______________________________________________________ WARRANTY POLICY All products of Kussmaul Electronics Company Inc. are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 3 years from the date the equipment was shipped.