Settings Menu - InFocus ScreenPlay 7205 User Manual

Settings menu

:
allows you to assign a particular input to a specific source key on
Sources
the remote and enables or disables Autosource. When Autosource is not
checked, the projector defaults to the last-used source. If no source is found,
a blank screen displays. When Autosource is checked, the projector checks
the last-used source first at power up. If no signal is present, the projector
checks the sources in order until a source is found or until power down.
You can use the Source Enable feature to eliminate certain sources from this
search, which will speed the search. By default, the check boxes for all
sources are checked. Uncheck a source's box to eliminate it from the search.
System
All options in this menu toggle between on and off.
Rear: reverses the image so you can project from behind a translucent
screen.
Ceiling: turns the image upside down for ceiling-mounted projection.
NOTE: It is recommended that all final image adjustments in Ceiling
mode are made once the unit has fully warmed up (approximately 20
minutes).
Auto Power: When Auto Power is checked, the projector automatically
goes into the startup state after the projector receives power. This
allows control of ceiling mounted projectors with a wall power switch.
Display Messages: displays status messages (such as "Searching") in
the lower-left corner of the screen.
High Power: Turn this on to increase the light output of the lamp. This
also shortens lamp life and increases fan noise.
Settings menu
Source 1
29
System menu
Sources
Source Enable