Electronic Control - GE GFDS350 Technical Service Manual

Electronic Control

The electronic control consists of a control board
and a power board.
Power Board
Control Board
To remove the electronic control board:
1. Set the control panel in the service position. (See
.)
Control Panel
2. Remove the 6 Phillips-head screws that attach
the selector board to the control panel.
To remove the electronic power board:
1. Remove the top panel. (See
2. Disconnect 11 wires and wiring harnesses from
the power board.
3. Remove the 2 Phillips-head screws to release
the power board from the power board bracket.
Disconnect
Disconnect
)
Top Panel.
Disconnect
– 45 –
Note: If replacing the electronic control, transfer the
model selector harness to the replacement control
board in the same location as on the original. If
harness is not transferred, it will generate an E8
fault code. (See
Service Test Mode.
Model Selector
Electric Models
Gas Models
)
(Non – Steam)
(Non – Steam)