Impex Marcy Platinum GS 99 Owner's Manual page 17

STEP 9 (See Cable Loop Diagram & Diagram 9)
A.) Attach the 108" Upper Cable (#37) to the front opening on the Upper Frame (#6). Attach a
Pulley (#56) to the opening. Secure it with one M10 x 2 3/8" Allen Bolt (#83), two Pulley
Bushings (#55), and one M10 Aircraft Nut (#96). Draw the Cable towards the back of the
machine. Note: Make sure the Ball Stopper is underneath the frame.
B.) Attach a Pulley to the bracket on the Upper Frame. Secure it with one M10x1 ¾" Allen Bolt
(#82), two ¾" Washers (#99), one 2 7/8" L-shaped Pulley Bracket (#50), and one M10
Aircraft Nut (#96). Pull the Cable over the Pulley then downward. Install a Pulley to a Flat
Double Floating Pulley Bracket (#25). Let the bracket hanging for now.
C.) Draw the Cable around the Pulley then upward to the second open bracket on the Upper
Frame. Install another Pulley with a U-shaped Pulley Bracket (#51).
D.) Draw the Cable around the Pulley then downward to the Selector Rod (#29). Securely thread
the end of the Cable through the Weight Selector Pin (#46) into the Selector Rod. Use the
Nut at the end of the Cable to tighten down the Bolt.
16